Hello frends! Im trying switch from old scool stye developing (nrfSDK->arm-gcc->open OCD->st link V2) to nrf Connect SDK. My first goal - run blinky on custom board. And im have some problems. Blinky compiles without errors, but MS VS code show me errors in main.c - GPIO_DT_SPEC_GET. Im read about similar errors, but on this point not understand where is dig.
Chip - nrf51822 qfaa. When im use old way - my custom board works property.
my prj config, defconfig and board file. OS -Win 10, nrf Connect SDK - 2.2.0
CONFIG_GPIO=y
CONFIG_SOC_SERIES_NRF51X=y CONFIG_SOC_NRF51822_QFAA=y CONFIG_BOARD_MYTAG=y # Enable MPU CONFIG_ARM_MPU=y # Enable hardware stack protection CONFIG_HW_STACK_PROTECTION=y
// Copyright (c) 2023 Nordic Semiconductor ASA
// SPDX-License-Identifier: Apache-2.0
/dts-v1/;
#include <nordic/nrf51822_qfaa.dtsi>
&gpio0 {
status = "okay";
};
/ {
model = "MyTag";
compatible = "nordic-semiconductor,mytag";
chosen {
zephyr,sram = &sram0;
zephyr,flash = &flash0;
zephyr,code-partition = &slot0_partition;
};
leds{
compatible = "gpio-leds";
led0: led_0 {
gpios = <&gpio0 29 GPIO_ACTIVE_LOW>;
label = "My led";
};
};
aliases {
led0 = &led0;
};
};
&flash0 {
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
boot_partition: partition@0 {
label = "mcuboot";
reg = <0x0 0x8000>;
};
slot0_partition: partition@8000 {
label = "image-0";
reg = <0x8000 0x1a000>;
};
slot1_partition: partition@22000 {
label = "image-1";
reg = <0x22000 0x1a000>;
};
scratch_partition: partition@3c000 {
label = "image-scratch";
reg = <0x3c000 0x2000>;
};
storage_partition: partition@3e000 {
label = "storage";
reg = <0x3e000 0x2000>;
};
};
};
