Hi
We are developing software for the nRF51 with Keil under VirtualBox. Previously we used the PCA10000 dongle with the Master Emulator and MCP without issue. Now, with...
We are using nRF51822 for our products.
We want to know the min value of "Receiver sensitivity" when we use this chip for BLE.
The Datasheet says "Receiver sensitivity...
Dear
The BLE Multi-link example (ble_app_multilink_central and ble_app_multilink_peripheral)
shows how one central device can connect to multiple peripheral devices. ...
In the MCP app, if I have the following service data for an Eddystone beacon:
0x10, // Eddystone-URL type
0x00, // TX power in dBm. This is a signed integer so 0xEE ...
I have the nRF Control Panel Android application. It works fine with several BLE devices, but specifically for the Fitbit Flex, it fails to connect.
I know Fitbit wristbandes...
Hi,
The situation:
I was able to successfully receive known packets from a device running gzp_device_dynamic_pairing, from, the host running the gzp_host_dynamic_pairing...
Hi everyone
nrf51822,softdevice s130 2.0.0
now i used softdevice s130 establish two connection as a central with two s110 peripheral device,at the same time i establish...
Hi,
I want to write flash using received data in BLE interrupt handler(on_ble_evt()).
When i received some data from BLE, i try to write it to flash and wait until done...
Hi
I'm trying to use the nRF52840 USB Serial UART device (aka USB CDC ACM) however I can't find a Windows driver for this device
The VID is 0x1915 and the PID is 0x520F...
I need to copy a string, but i don't know how to define nor how to copy.
This is the string that i have to copy dev_name.p_data.
I use soft device S130 in NRF51
Hello,
using the nrf Toolbox and the UART menu I can connect to my nrf52 and if I navigate back to the initial screen the iPhone disconnects but the GAP_EVT_DISCONNECTED...
Hi, I have a peripheral device which has buttons that connects to a central device which is the NRF52 board. When the peripheral device is connected and buttons are inputted...
Hello. I am at the point in my project (using sdk v12) where I need to get DFU implemented.
In my case, DFU must occur through an alternative transport that is none of...
I'm using SD132 as a central, that I want to connect to a custom peripheral device.
I first add the 128-bit base UUID with: sd_ble_uuid_vs_add(&mys_base_uuid, &p_mys_c...
I'm having a lot of trouble trying to program both an application and a softdevice (S132) onto my board. If I use nRFgo to program the softdevice, then try to program the...
Hi I am using sdk 11 and adding DFU to my application
My application always stuck at dfu_ble_svc_peer_data_set(&m_peer_data);
in function 'static void dfu_app_peer_data_set...
Hello all,
I try to instantiate an uart driver using NRF_DRV_UART_INSTANCE macro, but I got the following error :
sdk/components/drivers_nrf/uart/nrf_drv_uart.h:97:1...
Hello,
We are developing an application in which we have an NRF51822-CFAC with sd110 v7.0.0 together with very small energy allowances. Our problem is that we cannot get...
On an ble advertising timeout an event is dispatched to : ble_advertising_on_ble_evt(p_ble_evt)
I notice the application restart and suspect it due to :
ble_advertising...
