Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi there,
We've had our own custom controller made, based on nRF52 (Rigado BMD-300 module).
In the last half of January we'll have a baseline firmware working, but we...
Hi, sending a data packet, then sleeping (memory retention mode), then sending another identical packet causes the receiver to send back an ACK for the first and trigger NRF_ISR...
Was sd_ble_gatts_value_get changed from s 110 to s 132?
Please tell me how it changed.
sd_ble_gatts_value_get(uint16_t conn_handle, uint16_t handle, ble_gatts_value_t...
Hi team,
I have nRF51822 DK SMA connector module(PCA10005) and j-link lite cortexm-9 JTAG/SWD emulator.can u please tell which sdk version are used for this modules.is...
hello
i am using redbear lab's ble nano with nrf nrf51822 chipset in it. now i need to permanently store some data like sensor values and mac address of central devices...
I'm not able to find an older legacy version of Softdevice S110, specifically 7.2.0.
In the SDK Version 7.2.0 obtained from:
developer.nordicsemi.com/.../
there is...
Hello
I want to establish the connection between nrf51822(base station) and:
the second nrf51822(transceiver)
android smartphone(transceiver)
It has to be possible...
Could someone offer some guidance in how it is possible to keep the radio within IDLE mode between transmissions when operating in ESB mode? I have a sequence of transmissions...
Hi
I'm doing some S/W based on nRF51822_xxAC. I want to split RAM into 2 regions, as following:
+-------------+ 0x20008000
|__ __ _ __ |
|APP ZONE2 |
+-------...
hello, I'm trying to read the status register but all I am receiving is 1111 1111, I tried to change the code to read RX_ADDR_P0, but I also receive 1111 1111. can you tell...
It suggests that it holds the permission regarding whether a chara. can be read, but isn't that kinda redundant since there are tons of other similar properties out there...
