Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Good morning everyone,
we have developed a custom board featuring the NRF52840. The device works fine, but I am having a hard time in making the USBD work.
I took most...
Hi
I am working with a Nordic nrf52840dk using segge and sdk 16.
I am using the nordic UART example in examples/peripheral/uart.
The issue I am having is that my data...
Hi
I try the example from here for a DFU OTA: https://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic.infocenter.meshsdk.v3.1.0%2Fmd_doc_libraries_dfu_dfu_quick_start...
Hi,
I have a nrf 52840 DK with me. I have downloaded the SDK for the mesh(v.3.2.0) and SDK (v 15.3). I am using segger embedded studio here. I have modified SDK_ROOT location...
The replies aren't showing in my original post and I can't add replies to it for some reason.
https://devzone.nordicsemi.com/f/nordic-q-a/55304/sdk15-3-0-sd6-1-1-ll_length_req...
Hi,
I developing a application with the nfr52840 board with SDK 15.2. i have started form the ble_app_cscs example for development my code. I I would like to send packet...
Segger Embedded Studio seems to use the full path of the FILE for the __FILE__ macro. During development this can skew the size of the final image if there are lots of trace...
I am working on a ZigBee coordinator device that will collect data from various sensors in the network and forward them to a gateway. I have started with the CLI example and...
We have custom board based on nrf52840 and using an application based Zephyr RTOS platform.
Sometimes, it is observed bus fault and hardware exception logs are observed...
Hello,
I am really wondering about the design of the UARTE peripheral. The documentation for the nrf_drv_uart and the nrf_serial library is lacking quite a bit. Most of...
Dear Nordic:
My NRF51822 based SDK9.0 can not connect HuaWei mate30 mobile,but it can work for any other mobile with android system.I used nRF master pannel APP downloaded...
Hi!
I'm having trouble getting any response from an NRF52840 MCU on a custom board we've made.
I'm hoping someone will be able to point me in the right direction by detailing...
I'm using pc-ble-driver(C program) to get the data from other device, I can get character now, but I don't know how to turn on the character's notification like the start...
