Hi All,
I am currently evaluating how I can charge a single cell with the nPM1300 PMIC with a USB-C connector, with the addition that the same USB-C connector should be...
Hi, on nRF54L15 Dev Kit, we are trying to validate our sleep current consumption. We are seeing sleep current of ~100-300uA, when it should be a fraction of that. As per datasheet...
I use nrf5340 DK as AP, nrf54l15 DK as TAG.
Below was uart print comments from AP
ESL_AP:~$ > esl_c bond_dump
esl_c bond_dump
Dump bonded device
ESL_AP:~$ > esl_c...
Hello,
I am implementing the Physical Activity Monitor Service which looks like this:
/* Physical Activity Monitor Service Declaration */
BT_GATT_SERVICE_DEFINE (...
We have an existing application that is based on asset tracker V2. It has been running since version 1.7.0 I have migrated to V2.9.0 a long time ago and it is running flawlessly...
Dear Team,
I would like to know if it is possible to add custom attributes and commands to standard clusters, such as the Occupancy cluster. I have reviewed the "Adding...
There have been a couple of questions asked that are similar to my question but in the interest of getting more clarity I am asking a new one as others have had accepted answers...
So, I open a nRF51 project today and found out that it failed to build. Turns out my uVision lost all of the target devices in its list, leaving only STM32 F0 and L0 series...
I am trying to download the examples from NordicSemiconductor/nrf51-ble-tutorial-advertising
The link shows:
github.com/.../main.c
but when I click on it, or right-click...
hello,
i am uing nrf51822.now i am in trouble while running uart on nrf51822.please tell me which can i have to burn on nrf51822 for getting uart properly working.i am using...
Hi,
Is there any information on how much improvement the DCDC has over the LDO at 1.8V? I'm working on a heavily space-constrained application, and I'm trying to make a decision...
Hi, i am working on PWM Library example in which i a m configuared GPIO pin P0.25. then i am getting voltage variations 1.3 to 2.8 volts.
the problem is when i disable...
Hi,
I want to connect old nokia 3310 to NRF52 DK.
Please let me know if any one has information about it?
Based on my research old nokia phone uses M bus and F bus...
Hi,
We're working with very specific hardware which requires us to watch very closely. We're currently considering a blocking function in an ble event handler which can...
Hi all,
We are currently developing a BLE enabled sensor device. We want to use the NFC component to identify the sensor by writing a device ID to the tag.
Question...
Hi,
The comparator (COMP) in nRF52 can use three internal reference voltages (1.2, 1.8 and 2.4V). Is it possible to also output these voltages on IOs?
Best regards
...
hello there in my code,
APP_ADV_INTERVAL 64
APP_ADV_TIMEOUT_IN_SECONDS 5
using nrfsniffer i am getting 57 packets in 1 second.
i can't understand it. because APP_ADV_INTERVAL...
Hi!
I tried to some research in the forum but I would like you to assert my final decision.
My goal is to design a sensors network (at the beginning with five end-nodes...
