I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
hello,
my custom hardware includes 10 buttons connected to 10 GPIOs of a nRF52832. The nRF52 is placed in low power or eventually system OFF all the time, waiting for a...
hello i am using the nrf52840.
how i can set the 4Khz frequency in low_power_pwm.
low_power_pwm_config_t have period parameters. which value i need to assign to generate...
Hello,
I am trying to migrate to the latest S140 SoftDevice, but the migration document leaves a lot to be desired and is missing information. I've had issues running standard...
Hi
I'm migrating to SDK14 currently. My program seems to hit an infinite loop (or something of the sort) after I call my_service_on_connect() from my_service_on_ble_evt...
Hi all,
I have a custom board with a nRF51 and a DSP connected to eachother (SPI, UART and I2C) and since I have no connection to the nRF directly or any buttons I need...
I want to change the light-control example given in mesh SDK such that instead of using buttons to trigger messages, I want to connect client with mobile and control servers...
Hi, I am working with app_uart module and during the reception process sometimes there will be APP_UART_COMMUNICATION_ERROR event generated, my question is why there is such...
Hi,
I am testing with ble_app_uart code for handling UART data. If the data is more the device is getting disconnected from the central device. I am thinking that, BLE...
I am using SEGGER Studio on MacOSx.
When use the latest mesh SDK, I can run the light_control example and see the debug log in the Debug Terminal of SEGGER Studio.
However...
I have the test that spi communication between nRF51 DK(Master) and nRF52 DK (Slave).
use the example projects in SDK 12.2.
success build and writing but i have got...
I would like to utilize six Sampo S1 readers (yes, I only read for now, I know they can do much more) to count people entering and leaving a conference.
I am looking for...
I implement it with sdk 11.0 and a third party board.Firstly,I program s132_nrf52_2.0.1 SoftDevice by nRFgo Studio，secondly，i program dfu_dual_bank_ble_s132_pca10036. then...
