I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hello,
I am looking through the data sheet for the NRF52 and do not see anything for writing to NVMC.
I see you can erase and configure the NVMC using:
NRF_NVMC ...
Hello, i'm using a microcontroller connected to a nrf24l01p in rx mode,after receiving a packet it writes the ack for the next transaction,it only works if i add a delay ...
hi i am unable to find cause of issue i am working on BLE and PWM driver when i get data in nus_data_handler i am calling pwm init function. and then it is going to
ble_advertising_on_ble_evt...
Hi,
I am wondering if it is possible for a peripheral device to interpret and react to a specific value written to it's CCCD by a central device. In all of the examples...
Hi,
I'm using nrf51822 / sd130 / sdk 12.1.
I am doing minimizing current consumption.
My main function is like below.
I checked no wakeup in sleep mode.
But, current...
What is different between the two hardware versions? I notice there are several examples for the 10028, but not as many for the 10031. What is required to make a 10028 example...
I am trying to get nRF Connect 1.0.0 to bond with my sensor (which uses a nRF52832). This works from several other programs (CySmart on Windows, LightBlue on iPhone), but...
Hello Nordic Team,
I have a question about RAM Related Issue for our program or rather more generally in relation to a board test that we just received and for which, with...
I know the Project options can be configured in the iar_nRF5x.icf file, but there is no option for ram size. If the RAM start and end is given, I guess that is the ram size...
In the BLE Characteristics, a beginner's tutorial
Martin mentions:
Since this is a beginners tutorial we will keep it simple and leave the doors wide open. No security...
Hi. I am having trouble getting the sd_app_evt_wait() call to work correctly in my code.
My main program works like this:
<inits>
for(;;)
{
<read saadc>
<sd_app_evt_wait...
I have configured the nRF52832 as a GAP peripheral and wish to establish multiple concurrent connections between this and GAP central devices (Phones). Is this possible? What...
