I'm not able to debug any of example applications that uses non secure build. Non ns versions works fine. I have added CONFIG_TFM_CMAKE_BUILD_TYPE_RELWITHDEBINFO =y to my...
Hi Team,
We recently received our custom PCBs and are currently trying to configure pins P1.00 and P1.01 as UART0 RX and TX respectively. However, the UART communication...
Hi ,
1.In the example: In nRF5_SDK_17.1.0_ddde560_usbd_msc_1\components\libraries\block_dev\qspi\nrf_block_dev_qspi.c, I need to set the following 0xB7 bytes. How should...
During the development of a Matter over Thread product, I encountered the following issue:
After adding two Matter over Thread devices (an OnOff Switch and an OnOff Light...
Hi Nordic Teams :
I would like to check the current consumption by BLE DTM.
1. Is the table measurement is from 3.0V input?
2. I find the condition in the datasheet...
HI ALL,
nrf54l15dk,v2.8.0,peripheral_uart demo and no changes have been made.
Then add the following content to prj.conf
sysbuild.conf
mcuboot.conf
At this...
I'm developing my application with nrf 52832 and nrf SDK v17.
I know NCS is more powerful. I'm currently learning how to use it.
But now.I still need my application with...
Hello.
Due to expanding code size because of the peer manager i m forced to move to gcc and Eclipse.
So far according to the tutorial i`m proceeding fine.
But, after...
is that any requirement of soft devices in if i want to communicate with nrf51822 module???
try to connect touch sensor with NRF51822 and it's gives output in form of 0...
I need to drive low a IO from a GSM modem:
They suggested to this with a open collector driver. On other microcontrollers usually I have a floating option for the IO...
I've been fiddling around and becoming familiar with the app_twi transaction manager. I wanted to do a quick unscheduled read of a peripheral's configuration register before...
Hi All,
Has anyone had to go through the new Rx RF Blocking test specified in the new version of EN 300 328? It seem all products shipped to the EU after June 2017 need...
Hi
I am working with nRF52840 , since it is said that it can work on 64Mhz, i just want to confirm by using Oscilloscope.
You have any inputs that how i can check the...
Hi,
I am newbie to Nordic and I am building a program that samples adc value. I just wanna know about the difference between two functions "nrf_drv_adc_buffer_convert"and...
Hi,
I am currently working on a prototype with Silicon Labs Thunderboard sense. I am looking for a replacement product that has NRF BLE module. All I need is a BLE module...
Hi,
I am currently working on a prototype with Silicon Labs Thunderboard sense. I am looking for a replacement product that has NRF BLE module. All I need is a BLE module...
Does the S110 v7.0.0.3-alpha DFU bootloader support nRF51822XXAB (128k) part?
I'm trying to flash the DFU bootloader on my custom PCB that contains a nRF51822XXAB part...
Hello
I have an application to process advertising report even if it is duplicated.
Is there any way to control whether the soft deice shall filter
duplicate advertising...
Hello,
I am using the example "ble_app_beacon", I have compiled and tested (all works well).
I am wanting to add more data to the scan response by passing more data to...
I'd like to run a softdevice application with OTA support on a RIGADO BMD-200 Evaluation board . I've successfully flashed the softdevice, the app, and the rigado bootloader...
