hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
This is what I got after upgrading my nRF51 dongle firmware.
It always times out.
I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...
Hi all,
Good day.
Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time.
Thanks & Regards
Jenson
I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
Hi.
I read in the datasheet the nRF52832 has a unique UART.
I have a custom board and this board have to do this four different tasks:
Read data from a 1st UART device...
Greetings ...
I am facing problem in finding a coexist example for P10056. Example code is given only for PCA10040.
1)Is there a way to convert the PCA10040 code to PCA10056...
tag v1.1.0 (have done west update)
using SES 4.30c as suggested by nrf connect (latest SES did not work for me either). Compiled and flashed using SES
simcard inserted...
Hi, I've downloaded Segger from https://www.segger.com/downloads/embedded-studio/ , upon install I found that all of the nRF tabs were missing in this version. Looking through...
F:\nRF5_SDK_16.0.0_98a08e2\examples\ble_peripheral\ble_app_uart
I tested above example, found the speed only 3K per second. Do we have a way to increase the speed?
Hi,
I'm using an NRF51 Dongle as a central to connect to a BLE peripheral using LE Secure passkey pairing. I've got to scanning / connecting successfully, I'm just stuck...
Hi, is it possible to control mesh devices from outside the network ? My idea is to control the light servers inside mesh network via the user interface provided by Home Automation...
Do you have "technical" documentation for examples executed with Python?
I need to send those packets from my host controller, which does not run python.
Something like...
In case the DSM metadata is changed compared to what is stored on flash, the 4.0.0 code is supposed to clear the flash from any configuration but this doesn't work properly...
Hello,
I'm pretty new to rtos and totally new to nordic's nRF9160. I've been trying to get this working all day and can't really seem to figure it out based on the resources...
Hello,
We are using nRF52840 with SDK 15.2.0, a bootloader, the bootloader settings and the SoftDevice. Our product has a cellular modem to be able to perform OTA firmware...
Let say a situation where I want to know if the just connected client is the same as the one that was last disconnected, but if the client uses RPA than have somehow to try...
Hello,
I'm developing a BLE device based on nRF52832 and SoftDevice 112 using SDK 15.3.0. The device operates only in peripheral mode with only a single connection to the...
