Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hi
I'm have and NRF52840 with a MPU9250 connected via TWI. The connection to the MPU9250 is successful, I can find its address on the bus (0x68).
I've implemented a very...
I am trying to add to an existing project gpiote
I have copied the code from the example project and tried to add all the files and changes to my sdk_config.h to match the...
Hello all,
I'm trying to develop a basic bike computer, compatible with ANT+. For that, I'm using nRF52 DK. My main objective is to be able to connect to any commercial...
Hello,
I have nRF52840 with code that is based on SDK16.
I am not using Softdevice in my project - just MBR , Bootloader and Application.
I was able to upgrade my code...
Hi all,
We are successfully using the nRF52840 chip in one of our projects except for the DFU functionality. We tried following these tutorials without success:
devzone...
Hi, I'm dealing with the ble long_range_demo. Central packet gives arrival time and rssi signal through the rtt viewer. However, I am willing to know the sending time of the...
Hi all,
I am investigating Mesh SDK and interoperability between devices.
We have bought some Hytronik devices which are qualified with Bluetooth.
Strange thing is that...
Hi,
I am new to thread network. In my application only a few nodes, mostly one. How can I connect this one node to the internet? Assume WiFi is available.Can I use the thread...
Hi,
Good Day!
Statement of Problem: In our application, we are using a 3S2P Li-Ion battery(12.65V). BMS is built using BQ24XXX TI's Li_ion controllers (Which does not...
Hello,
For the past couple weeks I have been trying to get Gazell working concurrently with BLE using the timeslot api. Everything appears to be working correctly - all...
Hi,
In one of your posts , a few monthes ago, you wrote that LTE BLE gatway for thingy is "work on progress".
Quote: "We haven't made this demo for the Thingy:91 yet...
I am currently working on a low power application using the NRF9160 chip. During power optimalisation I found out that my sleep current can be reduced from around 50uA to...
