Hello,In normal condition, I use UART,pwm,spi an so on.Now I want to clear the configuration, and enter System ON mode.But I don't want to system reset.
How should I do...
Hi, everyone~
My goal is to collect data from 4 sensors simultaneously using iPhone.
Now, my testing code for sensor nodes is working fine. It was built based on the...
I am an android developer and I am using your nRF Master Control Panel (BLE) product as published on Google play. Below is the link to the app:
play.google.com/.../details...
I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
hello i am using the nrf52840.
how i can set the 4Khz frequency in low_power_pwm.
low_power_pwm_config_t have period parameters. which value i need to assign to generate...
Hello,
I am trying to migrate to the latest S140 SoftDevice, but the migration document leaves a lot to be desired and is missing information. I've had issues running standard...
Hi
I'm migrating to SDK14 currently. My program seems to hit an infinite loop (or something of the sort) after I call my_service_on_connect() from my_service_on_ble_evt...
Hi all,
I have a custom board with a nRF51 and a DSP connected to eachother (SPI, UART and I2C) and since I have no connection to the nRF directly or any buttons I need...
I want to change the light-control example given in mesh SDK such that instead of using buttons to trigger messages, I want to connect client with mobile and control servers...
Hi, I am working with app_uart module and during the reception process sometimes there will be APP_UART_COMMUNICATION_ERROR event generated, my question is why there is such...
Hi,
I am testing with ble_app_uart code for handling UART data. If the data is more the device is getting disconnected from the central device. I am thinking that, BLE...
I am using SEGGER Studio on MacOSx.
When use the latest mesh SDK, I can run the light_control example and see the debug log in the Debug Terminal of SEGGER Studio.
However...
I have the test that spi communication between nRF51 DK(Master) and nRF52 DK (Slave).
use the example projects in SDK 12.2.
success build and writing but i have got...
I would like to utilize six Sampo S1 readers (yes, I only read for now, I know they can do much more) to count people entering and leaving a conference.
I am looking for...
I implement it with sdk 11.0 and a third party board.Firstly,I program s132_nrf52_2.0.1 SoftDevice by nRFgo Studio，secondly，i program dfu_dual_bank_ble_s132_pca10036. then...
Hi experts
I am trying to interface an external ADC to NRF51-DK i am presently reading SPI ADC code values on BUTTON press event. I am able to read the values from ADC...
