Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi,
I am using central s120 with peripheral s110. The connection to the peripheral is depending on the name advertised by the peripheral.
When connection is done, the...
Hello,
I am trying to ecrypt some data in order to send some data encrypted in the MINOR and MAJOR adverts of the device.
I used this code to ecrypt the data ( this is...
Hi,
i use anRF51822 with soft device 7.
I run the UART app on my iPhone 4s with ios7 and on the nrf51822 board the ble_app_uart with keil uVision5.
Both devices connected...
Hello,
I upgraded nRFgo Studio software to version 1.17.0. Installation goes OK but the application crashes every time I try to launch it after installation process.. Then...
Hi,
i tried to send data from ios 7 via tx_characteristics(like in UART example) but received error:
didWriteValueForCharacteristic 2A38 error = Error Domain=CBErrorDomain...
I have been trying for a few days now to get my environment setup for development with the nRF51822. Since there is no official configuration for the Mac w/ Eclipse I have...
I tested BLE mesh example. I have 4 boards 1 nRf52832 and 3 nRF 52840
1 board as client(nRf52832)
1 board as Provisioner(nRF52840)
2 board as server(nRF52840)
i loaded...
Hello
I'm trying to use the secure bootloader from the SDK Examples. It worked all fine with downloading and the example package.
But if I try to make my own application...
I am trying to come up with a BLE solution for a Linux based audio project. The Linux target would function as a hardware appliance and as such would appear as a BLE peripheral...
Hello Community,
I have been trying to avoid asking this question here (it may be trivial) but I guess the answer will help other people as well.
In the ATT_MTU throughput...
I was on Instagram, and I won a green nordic 52 from Nordic. I got it, became frustrated because I didn't have a JTAG debugger, and flashed espruino onto it with nRF toolbox...
Hello,
I have a question regarding the correct way/good practice of programming with the use of SPI. I am using SDK 15.0.0.
I've written some code in a source file peripheral...
hi.........
i am using nrf52832 and segger 15.2
i am merging the two programs in order to send the data through ble to phone(uart app)
i am getting the error
undefined...
hi !
I have start to program the SPI example to communicate with the BMP280 from Bosch and i have seen good results so i'm tried to implement the code over ble_app_uart...
hi..........
i want to put my peripheral device in sleep mode ? how to do that?
i tried this one , its shows error
err_code= sd_power_system_off();
APP_ERROR_CHECK...
Dear Nordic Team,
Thanks for supporting.
Currently i am trying to work with multilink central in NUS_C example based on ble_app_multilink_central. The edited code was...
