Hi All,
I'm using nRF24L01P for TX device and want to receive packet from nRF51822 RX device.
nRF24L01P TX device Register settings are as follows;
Reg.EN_AA=0x00...
I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
I'm using the nRF51822 eval kit
I have installed MCP but after starting I get pop-up: Master Control Panel has stopped working
In nRFgo Studio / Device manager pane...
the proximity example is running ok. but when I modify the length of the alert_level I have the following error on the server side that I am not understanding.
476;16:12...
Hi all,
I'm working with the nrf51422 and the nrf51822 and I was wondering what the current status of the over the air DFU system is.
I'm using SDK 6.0 and I managed...
nRF24l01+ at a transmitter module one time successful transmission show & after 1 sec failed also . if any doing programming with atmega32 ,please send code for TX & RX ....
Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi, I'm using the nRF8001 in an application that requires security so bonds to the remote client/central. My device supports firmware upgrades that may involve new nRF8001...
Hi,
As I’ve mentioned in a previous post (answered ! Thank you Aryan !), I'm writing a bootloader for nrf51822 to be able to update the nRF51's firmware through SPI (data...
Dear community and support,
I am trying to install Master Control Panel 3.9.0.6-x86 on a Windows-XP virtualbox. The installer fails with the following message :
"The installer...
I want to send a float as a value of a characteristic.
As I know is this all what I have to change to send a float...
float temperature;
uint16_t len = 20;
attr_char_value...
Hello,
i have an urgent problem that i need help.
I have designed a board using nrf8001 IC and manufacture 5 samples. They are working perfectly.
Then i went to production...
I am using the S110 softdevice from v8, and building the bootloader from SDKv8, using keil uv5.
The project is dfu_dual_bank_ble_s110_pca10028, loaded from the dfu_dual_bank_ble_s110_pca10028...
Hello, Greetings, in the nRF24L01 datasheet, it's mentioned that the module can work as a multiceiver using the six parallel data pepes,my question is that if it is possible...
on an arduino+redBear Shield 2.1, I read an analog port and write the value to the serial monitor and to my bluetooth connection with
ble_write(analogRead(0));
Serial...
I can't find anything related to this in the docs :(
In the client_handling.c is a function static void on_evt_hvx(ble_evt_t * p_ble_evt, client_t * p_client, uint32_t...
I have been unable to get an ISP130301 module to work with the example dfu s110 bootloader. Dual band, single bank, all of the sdk and SD variants. I've followed the tutorial...
I want to store sensor measurements taken every 2.5ms persistently. Does a write to the internal flash happen faster than this? Can I safely assume that the internal flash...
Could somebody, please tell me what it means? I couldn't find it in the docs.
uint32_t bleDeviceManagerInit()
{
uint32_t errorCode;
dm_init_param_t params;
dm_application_param_t...
