Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I have a project (using a Ble Nano) that currently is running on Nordic SDK 8.1 but I want to update it to 12.2 . I currently use terminal to compile the project (I got the...
I am using Segger for Mac. I followed the tutorial on importing a Nordic example from the Nordic SDK 12.0 examples folder. It is the UART BLE Peripheral Example.
I got...
Hi all, I'm working on secure bootloader SDk12, I made the required changes to work button less dfu now it jumping from application to bootloader but it needs write 0x01 manually...
The program is hanged when I use below code to set Manufacturing specific data (I am using SDK12.0.0 S130) Please comments.
uint16_t DataSize = 14;
uint8_t MfgSpecData...
Hello,
I would like to implement a precise timer which calculates/counts the time in microseconds which I can use for
calculating the time elapsed between parts of the...
Hi!
Does anyone run UARTE with EasyDMA enabled? I don't want to use interrupts and simply copy every received UARTE bytes to global tx_buffer....and pooling with amount...
Hi,
I want to produce a shared secret key between a Smartphone and a NRF52 in order to encrypt data later with AES-128 (example of key sharing: here ).
To do that i need...
Been having a bit of trouble porting our nRF51 project to nRF52 SDK11. It seems to not like using hal_cm4.c from RTX_CM4.lib with FPU. Seems to get stuck on OS_Tick_Handler...
HI，I want to store some data in 51822. These data was store by my program. I know the pstorage.c could store data. When I do DUF the data could be erased by the bootloader...
I am interested in optimising inputs for ADC measurement on an nRF52.
I have seen quite a bit about nRF51 but am unsure if this remains relevant for nRF52?
Hi!
I have an nRF52832 on a custom board. I managed to flash it through JLink and STLinkv2. But suddenly, I wasn't able to communicate to it anymore.
Openocd tells me...
Hi
The new signed DFU in the SDK12.1 comes along with a experimental buttonless DFU. There are a few bugfixes required to make it working, but the nRF Toolbox app didn...
Hi:
Recently, I want to use nRF52 to read or write some data from a flash chip(w25q128bv) by using spi, I've read Manufactures ID correctly, also, I have wrote a register...
Hello!
I need to interact with two J-Link debuggers, connected to the same PC at the same time. I would then read and write data to the devices connected to the debuggers...
