when creating a pairing with a peripheral, the application fails to exhange keys to allow for random private addressing so the peripheral cannot reconnect because the address...
Hi. i'm using nRF51822AC, SDK12.2.0, S130 v2.0.1 as central.
I want to make sure that how to operate DFU.
Please check there is missing point or wrong point.
Step 1...
Hi,
I'm struggling to get a mouse wheel to work in advanced (High Res) mode.
What I learned so far is that I should create a "Resolution Multiplier" Feature report....
i set up an coap/iot environment and but i was getting error while compiling code for adc i followed steps from this post devzone.nordicsemi.com/.../ here is the problem
Hi all,
I've developed a broadband vibration energy harvester that is able to pick up uW of energy from just a couple Hz all the way to 150Hz. I'm currently looking for...
We use SDK12.10 Main.c (d:\nordic\5142xx\software\org-sdk12.1\nrf5_sdk_12.1.0_0d23e2a\examples\ble_central_and_peripheral\experimental\ble_app_hrs_rscs_relay.
My question...
Theoretically, if I were to expose a GATT service to let a central write a 128 bit PIN to my characteristic, would I then be able to persist this PIN somewhere in the softdevice...
Hi,
I am developing firmware based on nRF51822 SDK for s110.
I would like to modify one or two bytes at Manufacturer Specific Data area in advertising data packet.
But...
Using nrf51822's PCA10001EK and trying the included s110 example called ibeacon. Keep hitting error 0x3001 which corresponds to "connection handle" error.
This error is...
I have not been able to make this app work. I programmed S120 as softdevice and loaded the application. Ran into problem with scatter file. I changed it based on the s120...
When sending data on a pipe with ACK (indicate), the acknowledgement seems to get lost if the device gets disconnected right after having sent that data. Is that a normal...
Hello,
I am trying to build a single device, lets say loaded with firmware "A".
I would like to have two of these devices, both with firmware "A" to detect proximity...
I can't find anything to indicate for sure that the S120 BLE softdevice will work on the nRF51422 BLE/ANT chip. I'm pitting BLE vs ANT for my current use case and being able...
nRf51422 flash data retention is 10 years at 40°C. We need for our application (motor control roller shutter) 20 years. What can you do to increase this value?
Hi All,
Please correct the following in my understanding. Also , i am planning to build a
remote controlled device using a PWM output. How does ATT,GATT and GAP affect/influence...
I recently purchased an nRF51822-mKIT and I'm having great difficulties in getting it to talk to either a Windows 7 or a Windows 8 desktop PC, or a Ubuntu linux desktop PC...
Hi.
I have just a question:
Can the same device work with gazell protocol and bluetooth LE alternatively?
I want a net with a host and some devices, but host must be...
I've somehow lost the ability to perform over the air DFU from Master Control Panel.
I have reinstalled the J-Link drivers, nrfgo studio, I've flashed the PCA10000. I can...
My board works most of the time are very good，but one time i power down the board when ble connecting and data transmitting，the board can't work when power on.and i can't...
