I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hello,
i am using the fstorage library for very simple persistent storage. How can i modify the linker script to put the storage at the end of the flash, and with a fixed...
I use next init in static void advertising_init(bool bonding)
ble_advdata_manuf_data_t manuf_data;
manuf_data.company_identifier = COMPANY_ID ;
manuf_data.data.p_data...
We have a custom board with the nRF51822 xxaa chip on it. The board is completely functional and uses SDK8.0 and S110 as of now. We are porting the firmware to SDK12 and S130...
Hello,
I have an authorized write long characteristic which I'm writing using nRF Connect. My peripheral app gets the expected sequence of events: 1) BLE_EVT_USER_MEM_REQUEST...
I made an app based on this tutorial on SDK version 11. But now I have to use the latest version 13. Everything changed. Is there an easy way for me to migrate to version...
Hi,
I'm in the process of evaluating the nRF52 for use with a Windows application I'm building.
I was able to setup a Central + Peripheral using nRF connect and this...
Hii this is vinu .iam trying to develop health thermometer service for central but iam facing problem in indication for specific measurement characteristic.and iam using cypress...
I am creating a BLE peripheral device and I am using peer manager in it. What is the maximum number of peers that my device can bond with? And what will be the result when...
The basic question is: if I initialize the SD and then forcibly change the priority of the WDT IRQ to zero via NVIC_EnableIRQ(), will that cause a problem?
I know you don...
Hi, We are using NRF52832 in our application. Can you please suggest swd interface module for programming NRF52832?? or tell me any cheapest way to program NRF52832??
nrf51 SDK9.
On peripherial one service has static passkey and it connected to another device on central nrf51 without problem.
I added sec open batt service on peripherial...
I want to undestand this. I can't see any examples with it. In the example ble_app_proximity I always received 100% level.
If it possible, can anybody give a ADC config example...
I am working with a Blend Micro Board (Arduino IDE with RBL_nRF8001 sdk), using
Evothings.
Using the RedBearLab Simple control example I can easily connect to the board...
