Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hello community,
Before I was using a pca10040 by Nordic evaluation board. The project, that i developed, is running well using the EB but when I change to sparkfun breakout...
Hello,
I'm working on nrf51822 with SDK9.0. I have two modules, one is working as a peripheral using s110 and another one is as a central using s130. Now central has a very...
Hi!
I am fairly new to programming micro controllers so apologies if I ask many questions.
I am using NRF52832. The situation is this - I have 2 devices and 1 host . After...
Hi all,
I've found the nRF52840 with USB but it seems a bit OTT for our application, something more like the 51822 would be nice, but cannot identify one, can anyone list...
Hello!
I have a code that is working perfectly on Eclipse for Linux and I would like to copy it to a windows computer with keil. I created a new project with Keil copying...
Hi, I'm developping endless PWM sequence.
That is ...
Only one output pin and the signal from it is repeated with the same period of pulse but with two different duty...
Greetings,
I'm having some trouble using the secure DFU bootloader and buttonless DFU service in my application. The code for both of these has been taken from their respective...
nRF52 SDK13 S132.
For example, I have handle from 0x180A service.
I want to read characteristic 0x2A24 from here.
How should do it?
In the watch window I can see event...
We are interfacing to a SPI Flash MX25R8035F.
When attempting to read 1 page of 256 bytes from the chip we break the read command up into 4 SPI Commands.
1) Read the Status...
Hi,
I`ve made fixes in SDK 13.0.0 files described below:
nrf_section.h : to supress gcc warning: invalid suffix on literal; C++11 requires a space between literal and...
When I set the PWM driver for very low frequency i can see how it blinks, the thing is that it always blinks where it's more or less 70% of the time ON and 30% OFF .
When...
Hello,
Working on a project using the pairing and bonding security model, I would like to filter out of a central's scan all already bonded peripheral devices. Or, I could...
For some reason I get a softreset instead of a sleepmode when I call sd_power_system_off();
Device: NRF52832
SDK: 12.2
S132 v 3.0
I do clear all gpiote interrupts...
Hi, in our project, we need to apply 51822 as MCU to control other devices. But we need 2 USART ports. I wonder is there any product in nRF51 series that can do this. Thanks...
