Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I'm using nRF52832 and S132 based on nRF5 SDK v14. I get a error code 4 when I add DFU service refer to the experimental_ble_app_buttonless_dfu . The SDK has changed so much...
Hi,
I'm wondering if I can get current transmitting channel during a connection. So
Is there a way I can directly read current transmitting channel?
If not, is...
This question has to do with the observed "recursivity" of the calls to "app_sched_execute" in SDK13 as described in the previously asked question below:
devzone.nordicsemi...
hi.
How do i do ble_app beacon advertisement to one device(Android phone) whose bluetooth address is known ?? I want that beacons should only be seen in nrf_connect app of...
I am trying to write my firmware in mbed instead of microvision. I have my own custom PCB w/ the nRF51822 and use SPI with different GPIO pins than the standard ones.
My...
On the following code I have a packet of 6 bytes that I write to a buffer. I pass the buffer as read_packet function argument. When optimized, the code doesn't work. I only...
It is possible to run easily a SoftDevice stack (e.g. S110) on nRF51422 using an accurate 16MHz external clock reference for HFCLK instead of an external 16 MHz crystal oscillator...
hi, nordic staff.
i'm working with s120 v1.0.0. and i recognize that the transmission and receive buffer is only one for every connection(up to 8 simultaneous connection...
First, I flash the softdevice, then I flash the bootloader, then I use a smartphone app to upload an application to the device via BLE.
but, The first operation only. When...
Hello Nordics.
I developed a device that display a navigation information using s110 (nRF51822)
My device receive the road information by an application.
But, when...
Hi,
I'd like to get a timer with 1ms interval or higher resolution, and found some questions about this:
If the app_timer is used, looks like we only can get minimum...
Hello Everyone,
Scenario is i am getting some commands from Master(Android based Mobile App) to start some function , After i get the commands i disconnect from master...
Hello,
I tried firmware over the air update with mbed using the compiled bootloader hex file and it works pretty well.
However, I am back to GCC with softdevice 7.1...
I looked up method about Transferring files.
and became interested about the example of dfu.
if I understand dfu example, I think it would help to me
so..
What...
Dear all,
In my application main function I am reserving 20 Bytes in Flash(using the pstorage_register(), so I can not manipulate adresses directly) , I store variables...
Hi nordic people,
I've tried to run the code from the RAM following this guide. After some optimization in the code I get it work without visible problems. According to nRF51822...
