Hi all,
I want to fully understand the concept of Bluetooth protocol using nrf52811. Any advice will be helpful for me!
First, as I understand softdevice is Bluetooth...
Hi，everyone:
We are developing a Nearby protocol combined with UWB, which needs to communicate with the Bluetooth of Apple phones and then use UWB to measure distance. We...
My product currently has DFU (Device Firmware Update) functionality enabled, but I want to allow firmware updates only after receiving a specific command via BLE. This is...
As shown in the figure, MCUboot has a boot_go_hook function. I'd like to define this function in my own project and compile it into MCUboot. Since I'm using single slot DFU...
Hi,
1.In ncs v3.0.0, can both USB DFU and UART DFU be enabled simultaneously on the nRF5340 DK board? 2. If USB and UART DFU can be enabled simultaneously, then how should...
Hello, My SDK is NCS2.8.0, I want to know the version of matter, but I can't find it, may I know how to get?
BTW, does NCS SDK support Matter 1.4.0, if yes, could you tell...
In our development using NCS-2.6.1 it is desirable to have logs using BT NUS.
"Serial Bluetooth Terminal" android application is used. Logs are having corruption.
Looks...
I started looking at the alert notification example. I just can't see how people understand the complex state sequences the peripheral (or central for that matter) go through...
I am using em::blocks and arm gcc with ble nano from readbear labs.
I built the template example but it is not working.
The output hex is the same as if i had built it with...
Hi, I am about to purchase PCA10040 V1.1.0.
I heard that one has the latest chip revision nRF52. ( ref. link )
I'm very excited to start with the new feature in nRF52;...
I have a peripheral and a central.I set my peripheral which have the function of static Pin,for example: When I use cellphone to connect to my peripheral , the cellphone must...
Hi all,
I am trying to read and write in ble central and peripheral code with softdevice s130. Here i can able to connect to particular ble device with unique ble device...
When trying to setup the gcc toolchain with Eclipse Luna IDE, I ran into the problem when I can't set a break point when debugging with the GNU ARM J-Link Debugging Support...
Hi,
I am new to Nordic semiconductor's chips. I recently got a nrf52 and I would like to make a portable temperature sensor using nRF52 dk. I have analog sensor that basically...
im using an external acceleromter to trigger an event once the device shaked. I configured the event pin on nrf51 EVENT_PIN as an input this way:
APP_ERROR_CHECK(acc_config_motion_detector...
Hi all,
I can able to blink led in mesh synchronously, but some time it fails in synchronization. when a new node enters into mesh it takes current mesh value, but for...
Hi all,
I am using ble mesh code for synchronizing leds in mesh network. I need mesh part, but itshould not integrated with version. So i can able change state of led,...
Hi,
I am a new programmer to the NRF51 and I was wondering if someone would look at my code. I am trying to program the NRF51 to take ADC samples at a frequency of 1 kHz...
