Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hello,
could you please explain how the time synchronization works?
What does the function sd_ant_time_sync_broadcast_tx(...) do?
Does it include the rtc value of the...
Hi,
I am facing an issue. I have an iOS app and a glucose application.
When i pair with the iOS device it works fine.
If i do forget device and again pair after forgetting...
Hi,
I am working on BLE device [prototyped using Keil v.5]. It connects to a smart phone app. I would like to build in some security features, definitely some form of Transport...
I'm testing one hardware with Nordic apps on various mobile platforms. For Android and iOS, Nordic apps works just fine. But for Windows I could find only nRF Toolbox(no nRF...
I'm using nrfgo studio to try and design the connection parameters for an application, and in particular using the current consumption tab to get estimates of power consumption...
why there are two inductor in series in DC/DC regulator ckt, is that inductor value is so critical?instead can we use only one inductor? what are critical selection parameter...
debug the code and found a 0x1001 search the code and found
NRF_FAULT_ID_APP_MEMACC
it means my pointer try to operate the ram those range in sd?
sdk11 and sd3.0.0...
while compiling my project it is showing a error in app_timer.c which is on line 62 STATIC_ASSERT(sizeof(timer_node_t) == APP_TIMER_NODE_SIZE);
The error is that it is divided...
Hi,
I'm working on the example ble_app_hrs with s110 on the pca10001 board and I would like to know how do I add custom service and characteristics. Do I need to modify...
Nevermind: my problem seems to have been: you need a battery at 3V powering a BLE Nano to program it from a nrf52DK.
Original question: I have connected a nrf52DK dev kit...
Hi all,
I am new to write firmware of ble device(Bluz). I wanted to change the default firmware of ble device. For that, I wish to write own firmware. Please guide me,...
Hi
I'm trying to catch the GPIOTE_IRQn interrupt, while the device is in system off.
Not enabling the SD130 V2 the interrrupt is caught once, and then not anymore...
...
Hello,
I'm currently trying to pair my board with my phone and I've faced some issues.
After downloading my device(NRF52 PAC10040 board) with experimental_ble_app_blinky...
