Hello everybody,
I am trying to get the RTC0 peripheral working on Nordic nrf9151-DK using libraries from Nordic (nrfx_rtc.h, nrfx_clock.h and hal/nrf_rtc.h). I am not...
Hello everybody,
I am trying to get the RTC0 peripheral working on Nordic nrf9151-DK. I wanna use zephyr/driver_rtc.h library and zephyr/device.h librrary. I am able to...
I'm not able to debug any of example applications that uses non secure build. Non ns versions works fine. I have added CONFIG_TFM_CMAKE_BUILD_TYPE_RELWITHDEBINFO =y to my...
Hi Team,
We recently received our custom PCBs and are currently trying to configure pins P1.00 and P1.01 as UART0 RX and TX respectively. However, the UART communication...
Hi ,
1.In the example: In nRF5_SDK_17.1.0_ddde560_usbd_msc_1\components\libraries\block_dev\qspi\nrf_block_dev_qspi.c, I need to set the following 0xB7 bytes. How should...
During the development of a Matter over Thread product, I encountered the following issue:
After adding two Matter over Thread devices (an OnOff Switch and an OnOff Light...
Hi Nordic Teams :
I would like to check the current consumption by BLE DTM.
1. Is the table measurement is from 3.0V input?
2. I find the condition in the datasheet...
the nRFgo studio is used as a visual editior for the nRF8001 to create Bluetooth low energy Services and Characteristics and Pipes to access them. After creating the Service...
I'm trying with a nRF24L01 device, connected to an Microchip MCP2210 USB/SPI bridge.
With this Microchip device, i cannot sent a CE pulse shortest than 130uS to transmit...
Hi,
Can the nRF51822 be set up to run thr 32kHz clock in mode?
What is the lowest possible sleep current while maintaining BLE connection timing?
Thanks
Vladim
Hi all,
I would like to use LE1 to control Remote controlled car. But we have been used another vendor's chip in the car by now. Is it possible to connect between them...
Is there any equivalent to the SPP profile from Bluetooth Classic? I've always used this as a way to transmit custom data using Bluetooth, but I can't seem to find anything...
The Development Kit came with a J-Link Lite, which I've been using to program the development kit modules. As I'm now about to manufacture my own PCB, I was wondering whether...
I've done a few modifications to the default heart rate application in SDK 4.2.0, but now I can't see it advertising any more. Also, there is no longer any LED activity. Any...
