I have a simple GATT server application with two characteristics, RX and TX. In my prj.conf, I am trying to disable pairing as follows :
I can connect to the server from...
Hello,
I am trying to use LTE connectivity on a custom board with a nRF9160 SICA B1, but i am facing issues with the modem.
With both my own app firmware and the sample...
I have searched all responses here and whatever sources I can find, but not have any success. The main problem is that existing materials appear incompatible with the 54L...
Hi, I have test the throughput using two nRF54L15 DKs and make them close to each other.
My result is:
1. My first question would be: the best througput for 2M phy is...
Hi,
We're working on a project using the nRF5340, where we interface an external NAND flash (4096 blocks) to store high-volume sensor data. We are planning to maintain an...
Hi,
We are currently evaluating the NRF9151 for asset tracking using the AT firmware on the NRF9151 evk and an external MCU for the application firmware, emulating the final...
Hello,
We’re Bachelor’s students developing a project to estimate the angle of arrival (AoA) using a BLE antenna array on the nRF52833. Our implementation builds on Zephyr...
Hi,
in order to find out how Android nRFToolbox App works, I downloaded Source Code on:
https://github.com/NordicSemiconductor/Android-nRF-Toolbox/releases
I unzipped...
Hi,
I am using nrf_gpio_port_read to read port 1 (pins 8-15), and I want to know how long it takes to read the port, ie. how many instructions. I am doing this in an interrupt...
I have a need to maintain current state of my device along with other parameters, including temperature and hours used. If I update my pstorage page frequently, like once...
Hello,
I'm working on S110 peripherial <-> S120 central project using GATT. I have succesfully implemented S110-based peripherial device with some custom characteristics...
Hey All,
I am trying to create a simple data transfer system using a DFRobot Bluno (CC2540 chip) as the central device, and a Redbear Labs Blend (nRF8001 chip) as the peripheral...
Hello all,
In many thread I can read that it is not recommended to use the internal DC-DC converter to supply the nRF51822.
Can you tell me why it is better to use an...
Greetings all -
We have an nrf51-dongle for development and testing purposes, and are unable to connect to the device over USB with any of the Segger or Nordic tools. I...
Due to BLE's low range, license costs and unneeded complexity, I am looking in to pure radio RF. I am curious about ESB and Gazelle, and which one is good for relatively simple...
Testing OTA using nRF Toolbox on Android. Everything works fine, but for some reason the file selection is "stuck" in dropbox, i.e. I can not go up a level from dropbox, and...
my development environment is nRF-DK and IOT SDK
Q1 : IOT SDK Support Gatt Profile?
Q2 : IoT SDK Support DFU mode?
Q3 : in ipv6 coap server example, how i broadcast...
Hi!
I have custom board with nRF51822 and I need to communicate with serial flash W25X40 using SPI master example with SoftDevice enabled (S110 is used). I worked with...
Hello Everyone
i am using LINK LOSS service i would like to send notifcation to the peer device if the connection is lost and also if the connection is made between two...
