Hello,
I would like to obtain some information on the possible substitutes for the nRF51822 (BGA Packaging).
I received notification that right now only the final orders...
I am using the nrf9160 for an OTA firmware update application. I initially executed the fota download file from the http_application_update sample project in it's default...
Hello Team,
Could you please share some sample application or procedure to handle power modes (Sleep, Deep Sleep, etc) of the nrf9160.
Please let me know.
Regards, ...
Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Folks,
This is probably a C question as much as Nordic, so I might be told this is off topic. That's fine if so, I can try Stack Overflow.
I never use macros in my C code...
There is ble_gatt_db_srv_t structure type defined in ble_gat_db.h. It has a field named charateristics. It should be characteristics. Is it going to be corrected or it will...
Hi, Suddenly I can not connect to my nRF5280 PDK (PCA10056 0.11.0 2018.3)
1. I tried using JLinkExe and also SES, the same result, I got error "Can not connect to JLink...
Pins are denied to work as GPIO after the TWIM "Initialization -> Deinitialization" cycle.
After deinitialization, respectively, disable pins from the periphery, using the...
Hi all,
I am extending the BLE Multi-link example from SDK 15.2.0 in order to have some characteristics as BLE Mesh. I would like to use UUID filter to scan all peripherals...
I'm seeing similar problems to others in getting highly unreliable connections to the network. I *VERY* occasionally get LED3 and LED4 to blink simultaneously, but it's very...
Hello.
I take the flash_fds example from nRF5_SDK_15.2.0_9412b96, but I am not going to use the CLI (command line interface) because I take the FLASH written, reading capability...
Hi,
I am using nRF52832's ADC function to do my project, and I have an analog signal level problem.
I am try to connect MPX5100 sensor to nRF52832's ADC port, but the...
I am trying to use ARM GCC in macOSX and successfully generated .HEX file with the most simple project: the blinky project without softdevice. After setting up the project...
I am trying to use dsm_local_unicast_addresses_get() to store the address of each node, however it seems that when the board is restarted the value is lost, and node_address...
Hi,
I have troubles using nRF Mesh with my Vendor model.
I have made a Vendor Model that should allow me to send messages through Mesh. Once my boards are provisionned...
Hey everyone
This is sumanth, I am working low power node in mesh networking, I followed the procedure mentioned in below link for building and flashing
https://www.nordicsemi...
