Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi ,Sir:
We have a smart pen coming to market, but we have a problem with directed adv(based on SDK14.2 ble_app_hids_keyboard ). The problem is following:
when the pen...
Currently, we are developing power-saving firmware using nRF 52 Development Kit (for nRF 52832).
I wrote Nordic's SDK and executed it, it was a measured current of about...
Hi
I use nRF52832, SDK13 and S132 to develop peripheral which connects to smartphone.
Then I have to do a feasibility study that the peripheral can plays beacon role...
Folks,
This is probably a C question as much as Nordic, so I might be told this is off topic. That's fine if so, I can try Stack Overflow.
I never use macros in my C code...
There is ble_gatt_db_srv_t structure type defined in ble_gat_db.h. It has a field named charateristics. It should be characteristics. Is it going to be corrected or it will...
Hi, Suddenly I can not connect to my nRF5280 PDK (PCA10056 0.11.0 2018.3)
1. I tried using JLinkExe and also SES, the same result, I got error "Can not connect to JLink...
Pins are denied to work as GPIO after the TWIM "Initialization -> Deinitialization" cycle.
After deinitialization, respectively, disable pins from the periphery, using the...
Hi all,
I am extending the BLE Multi-link example from SDK 15.2.0 in order to have some characteristics as BLE Mesh. I would like to use UUID filter to scan all peripherals...
I'm seeing similar problems to others in getting highly unreliable connections to the network. I *VERY* occasionally get LED3 and LED4 to blink simultaneously, but it's very...
Hello.
I take the flash_fds example from nRF5_SDK_15.2.0_9412b96, but I am not going to use the CLI (command line interface) because I take the FLASH written, reading capability...
Hi,
I am using nRF52832's ADC function to do my project, and I have an analog signal level problem.
I am try to connect MPX5100 sensor to nRF52832's ADC port, but the...
I am trying to use ARM GCC in macOSX and successfully generated .HEX file with the most simple project: the blinky project without softdevice. After setting up the project...
