Hi
I am looking at section 9.1 of the S110 Softdevice Specification v1.3A and the release notes for 7.0.0-2.alpha where I see that an application now starts at 0x15000...
Hi
S110 v7.0.0-2.alpha got released today.
In the release notes it says...
[b]The SoftDevice can now be configured to forward interrupts to one of several applications...
Hi,
I use the nrf51422 chip.I want to know if the ANT establish link between chips,where can I get the matching configuration (like device type、channel ID).I mean is...
Is there a way to recieve more than one write callback for a given characteristic, per radio session? It seems like I can rx 1 time per attribute per radio session and tx...
If it can work with iOS blue setting will be better
I need some reference to dev hid device in IOS
but I can just find my device ,connect ok but not work.
I need to create timeout below 1ms. I would pretty much like to use timer for that because I do not want to hold the cpu inside cycle. For me it is not important the exactness...
Hi,
I had some troubles getting a custom HID device to work that has both input and output reports to Windows 10 host. Here is my working example template that might save...
I successfully created a custom model (by modifying the generic on-off model) and implemented it into light_switch client and server examples. The goal was to send and receive...
Hello,
I have implemented functionality that enables me to send messages back and forth between two nodes in the network with a timer (both nodes has a server and client...
Hi I have been using the https://infocenter.nordicsemi.com/pdf/nRF_Sniffer_UG_v2.2.pdf I wish to program my nrf52832 device with a hex. Using the j-link commander tool. i...
Hi - I built and flashed the ble_app_interactive example from both SDK 15.3 and then from 16.0 on to my nrf52840 DK (PCA10056). I connect to a Thingy52, issue the gatt services...
Tried with PCA10036 and PCA10031 on Windows 10. Both show as JLink CDC UART Port (COMx) in Device manager. Tried different versions of WireShark. Tried to erase and copy new...
Hi,
Using SDK 15.3.0 , example "ble_app_hrs_freertos", pca10040 with armgcc.
I want to increase MTU and GAP data length.
I started with MTU to 247, and when I try to...
I'm using SDK 16.0.0.
I wish to use two MEMS microphones to record audio over the I2S interface, and then send it over Bluetooth.
What is the best library to use for this...
Hello,
I have had issues in the past with twi manager causing ANT to drop out. These problems are ongoing despite me taking action in hardware to improve power supply (e...
I'm debugging on an nRF52832 (nRF52-DK, non-preview) using the ARM GCC toolchain and GDB under Eclipse on Ubuntu 14.04LTS, set up following the devzone tutorial .
At various...
When calling sd_ble_gap_connect(), and providing a whitelist, what is the expected process for establishing a connection, as far as timing is concerned? Will the device scan...
nRF52840. In case of standby current (battery only)
Measured as follows:
With only the battery connected, the same current draw as the one attached. Is there any...
In my DFU bootloader I am protecting areas of Flash memory used to store user data.
After an update, when my application starts and tries to write to this memory it is causing...