I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hello:
Why do I erase SDK5.2 version of flash and read not, in SDK4.2 can. I tested nrf51_sdk_v5_2_0_39364\nrf51822\Board\nrf6310\flashwrite_example is a good example.However...
before i write the flash, it has been erased.so ,its value is all 0xff.
when i write 0x00 to flash address 0x0001,the value read out is not 0x00 but 0x01,and the value in...
Hello, I am an intern at a startup company and ive been tasked with finding some information about the chip set we are using, specifically the bluetooth aspects. We are using...
Hello,
I just installed SEGGER Embedded Studio to build the light switch example for Bluetooth mesh.
I managed to successfully follow the quick start guide using 3 development...
Hello!
I managed to flash my Raytac dongle with debugging going using the SWD on a nrf52 DK. I am mainly working with SEGGER Embedded Studio and nRF Connect on Mac. However...
i m getting constant RSSI values 32 even if i move far or near
this is the same example code in ble_peripherals
I HAVE UPDATED MY CODE (i have printed the RSSI values...
I have an android smartphone of bluetooth version 4 and i am developing one application where i am using nRF52 (bluetooth version 5). Is it possible to write data from the...
Hi, We are developing a device for an Assistive Technology project using Nordic NRF52480. We would like to port to BlueTooth Generic HID (over GATT) an exising device, that...
hi...
I have modified the multi link central to multi link central uart , i can able to connect with 8 peripherals . One central getting connected with multiple peripheral...
I have the nRF52840 DK running a USB HID and an ESB PTX.
It is sending sensor data to a PRX continuously, with ACK.
The end product will be a power-sensitive device, so...
Hi,
I have verified some zigbee functions on nRF52840 and now it's time to consider real deploy phase.
Big concern about deployment of zigbee is
1) how to commission...
Hi,
I am developing a system similar to door lock system.
In our system, user data should transmit from ZED(or ZR) to ZC.
So i modified the ZB_ZCL_ON_OFF_SEND_REQ macro...
Hello?
I need to create 2 events on the same key with two operation like LONG_PRESSED and RELEASE after pressed it. (With precondition no RELEASE event after event of LONG_PRESSED...
Dear Sir,
I am interested in the direction finding of Bluetooth 5.1.
I found your product NRF52811 SoC on the Internet.
Should I use multiple antennae per one N RF52811...
