Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi
The BLE module operates in 2.4 GHz spectrum with 3 advertising channels & 37 data channels . Why advertising require 3 channels ? is it possible to make it to one channel...
When I initialize the SoftDevice with SOFTDEVICE_HANDLER_INIT(NRF_CLOCK_LFCLKSRC_XTAL_20_PPM, false); // Sets up Crystal Source to 20ppm 32.7628kHz
The project I based...
Hi,
First, I understand this are Android questions, but I want to appeal to this very knowledgeable community ;)
I have a BLE application using nrf51822 with SD 110...
int lbs
Hi,everyone,we change the uuid to
#define LBS_UUID_SERVICE 0x2101
#define LBS_UUID_LED_CHAR 0x3A01
#define LBS_UUID_BUTTON_CHAR 0x3A02
in nrf51-ble-app-lbs...
I am writing a custom Service. I need to catch when a Client tries to Read certain characteristics or Write to other characteristics. What is the best practice for Authorizing...
Hello support team,
If a message is received while the timer0 is running and the radio interrupt is enabled, the Radio interrupt hits and disables the timer interrupt....
Hi,
I have a simple application that requires command-response, and notifications interaction between an Android App and an embedded device.
The communication is bidirectional...
Hello,
I wonder how an ANT client should / would / could receive burst data. From what I'm read from the documentation, I guess that the received data will be passed to the...
Hi (I'm new at this, sorry for my question)
About Gazell & Pipe (nRF24LE1)
What is the utility of 6 or 8 pipe, whether only has 3 RX_FIFO for working simultaneous?
Can...
Hi All
I am trying to verify UART on one of our custom boards having nrf51822.
We have only one uart which we are using to forward the data received over BLE.
I am...
I use the demo : ble_app_proximity
to connect with android app
In android use this :
mBluetoothGatt = device.connectGatt(mContext, true, mGattCallback);
to set the reconnect...
Hi,
I'm checking out the new nrf51_sdk_v6_0_0_43681 for S110-SD-v7
Is there a revision-history available for the src files within the new SDK package?
For example...
