Hello Nordic,
My development environment:
SDK>> NRF51822_SDK10, SoftDevice>> S130
Example>> ble_app_uart
I am looking forward to your reply!
Thanks.
Best Regards...
Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I'm using nRF52832 and S132 based on nRF5 SDK v14. I get a error code 4 when I add DFU service refer to the experimental_ble_app_buttonless_dfu . The SDK has changed so much...
Hi,
I'm wondering if I can get current transmitting channel during a connection. So
Is there a way I can directly read current transmitting channel?
If not, is...
This question has to do with the observed "recursivity" of the calls to "app_sched_execute" in SDK13 as described in the previously asked question below:
devzone.nordicsemi...
Dear All,
I'm Starting the Design of nRf52832.
I need GPIO configuration of nRF52832 with its Alternate functionality like Peripherals UART, SPI, I2C and external Interrupts...
Hi,
I am new to nRF52832 software and Segger Embedded Studio. Was trying to comiple an example code based on ISP4520 which is based on nRF52832 device and am getting following...
Hi,
We are in the process of adding an external GPS antenna to our board and following the guides in the documentation feels a bit risky since names for circuit board...
I tried to redefine weak app_error_fault_handler by custom one (nRF5 SDK for Thread and Zigbee v2.0.0, Segger Embedded Studio), according to https://infocenter.nordicsemi...
Hello, I am currently in the micro selection process for a project looking to go to production that requires the capturing of an image and the sending of that image over Bluetooth...
Small bug report: MAX and MIN are defined in param.h. nordic_common.h redefines these macros which creates warnings if param.h is also included. nordic_common.h should check...
Hi , everyone
i want nRF52840 to acts as central and peripheral simultaneously . how can i achieve this ? i have seen in website nRF52840 can concurrent upto 20 link (multilink...
Hi,
how to connect multiple peripheral to single central using app , i wan to send the data from central to multiple peripheral and peripheral will also want to send the...
Hi, I'm currently developping my first app in java.
This app requires a direct connection with my BL652, which doesn' t accept any kind of pairing option. That being said...
I'm migrating a project from SDK 14.2.0 to SDK 15.3.0. I use gcc. I have three advertising modes and the first of them is working fine. For the second one, the same
ble_advertising_init_t...
