Debug Logger without softdevice, and the define ENABLE_DEBUG_LOG_SUPPORT to my project in the C/C++ tab.
i just test, very simple , but cannot get debug log..
int main...
I am trying to use the scheduler, but I would like to know if it is possible to have events with different priorities... As an example:
Task A - Priority LOW
Task B -...
FIXED (see below)
Hi!
I'm developing software for nRF52 on nRF52 preview DK, which I got on the Global Tech Tour.
LED blinking (blinky) example is running OK, so I moved...
Hello everyone,
I am using the great platformio toolchain that supports the mbed framework so far. I am still a newbie to it however.
I want to be able to use both the...
Hello!
I have a device with nRF51288. And I need to fill technical specification with the following parametres: operation freq., channel bandwidth, modulation, number of...
Hello,
Does anyone have a suggestion for a production programmer for the nRF24LE1 One Time Programmable version? I have been able to program the units with the nRFGo Studio...
Hello,
My board reads data from acceleration sensor and sends it to ESB message.
When acceleration is under threshold, nRF52832 went sleep mode.
Before entering sleep...
Hi...
I am using Nordic SDK V17.0.2 with a SoftDevice S112 and developing a project uses freeRTOS that came with this SDK
From reading the documentation about the...
my project ,sample data every 4ms comes in a GPIOE interrupt ,and in interrupt give a data come semophere , but in thread take this data come semophere and read data can not...
Hello,
I am using NCS v1.6.0 with the nRF52833 DK and would like to modify the TX power (e.g. from 0 to +4 dBm) and PHY (e.g. from 1Mbps to Coded PHY) in the peripheral_uart...
Hi!
I am running zephyr/samples/bluetooth/direction_finding_connectionless_rx sample application with minor modifications. I had no problem building application. I then...
Using nRF52840 DK with SoftDevice s140 latest version.
I have a data array that I am sending over a characteristic in fragments via notifications. Given the peer platform...
Hi,
I am considering a NRF52833 + nrf21540 combination. I see in nrf21540 product specification mentioned that
Single-ended 50 Ω matched input and output
...
Hello,
I want to create tfm_ipc project for NRF52840 DK board.
I configured options like below.
But I got an error message, "create_nordic_project.py failed (1)...
I looked at Blinky, but I am still not sure how to access the GPIO pins. In Blinky, there is an led0 alias, but what about other pins? What are there aliases?
Specifically...
Hello,
I used SDK15.3
Android phone and iOS phone is master
nRF52811 module is slave
It's said that the phone can't set conn international（Android、iOS）
But slave...
Hi,
i am working on "nrf52dk" . i want to use nfc pin as gpio.
what i did is
NRF_UICR->NFCPINS = 0<<0;
CONFIG_NFCT_PINS_AS_GPIOS included in preprocessor definations...
