hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
This is what I got after upgrading my nRF51 dongle firmware.
It always times out.
I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...
Hi all,
Good day.
Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time.
Thanks & Regards
Jenson
I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
Hi,
we've developed and produced a nRF52832-based custom PCB with custom firmware that is using advertising, scan, connection, custom Bluetooth service and characteristics...
Hi there,
I am designing my own custom nrf52832 PCB and would like to have my design evaluated before put it to production. I am just wondering if Nordic Semiconductor provides...
I am running SDK 15.2 on an nRF52840. I have programmed my secure dfu bootloader, application, settings.hex, and softdevice via jtag. During the first run after programming...
Dear fellow developper,
I'm trying to create a BLE device using HID service to control music, volume and so on.
I have successfully implemented a keyboard + Consumer...
Hello,
I would like to know if anyone else has faced this issue. Indeed, if i want all the consumer control interpreted in the right way, i need to add a keyboard in my...
I'm working on a project with nrf52840 and i'm trying to send and receive ipv6 packet throw thread protocol so i tried to use to send with otIp6Send and receive with otIp6SetReceiveCallback...
Hi,
We are currently working on a project involving a few Connectionless BLE advertisement transmitters based on nRF52832 (SoftDevice 6.1.0). On the receiving end we have...
Hello
I m hardware designing engineer in Turkey.
I m designing bluetooth controlled lighting armature. it must be connect other lamps. And must controlled by phone ios...
Hello all,
I got the nRF52832 dev kit and have been playing around with it. I am using Segger Embedded Studio V4.12. I tried out the ble_app_uart and the writable_ndef_msg...
Hello! I used the "blinky_rtc_freertos" example and transferred ticksource from RTC to SYSTICK in "FreeRTOSConfig.h". The application has stopped working. What am I doing...
Hi Every one,
In my application i want to use two UART's simultaneously, for that i am doing continuous switching of UART communication pins.
I am able to communicate...
Hello,
I am trying to designe my own iot sensor board with nrf52840
For my sensor board i will just add lipo charger IC and MPU6050 (accelerometer)
When i look at designe...
Is there a generic sdk_config.h file for each of the Nordic SDKs?
The ones included for each example seem to be missing useful macros/defines, for example, omission of SEGGER_RTT_CONFIG_DEFAULT_MODE...
