But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
HI,
i want to send a caps lock to BLE keyboard in report mode, but i had tested the sample in central_hid (NCS V1.5.1) and found that: It only can send caps lock in boot...
I need to transfer large amount of data from Android app at 2 mbps (it seems that bitrates about something like 1300 kbps are achievable) to nRF5340 device.
Data is audio...
Hi,
What would be the best practise to sample ADC with nRF52? ADC has its data-ready pin. I have tried use PPI with DMA, but realized that DMA current consumption is not...
When nRF9160 receives a TLS packet > 2048 bytes the socket closes unexpectedly. This problem has been documented in other tickets here and I believe noted in the nrf_modem...
Hello,
I am studying the NRF52 module and more particularly the 2.4GHz Radio peripheral of the module.
I would like to understand some things:
1 - sending at 2Mbps...
Shalom!
I have using the nRF9160 examples created an application for a future proposed custom board that when there is external power should always stay connected to our...
hello, trying to add pairing feature with LESC to ble_app_blinky_c, I got to a point where I get the following:
I don't find the definition of ocrypto_curve25519_scalarmult_base...
With current ESB implementation I'm not able to delegate radio event to other thread or workqueue. Kernels stays in idle (tickless kernel) and all radio frames are lost. One...
I am working on the nRF5340DK and NCS v1.5.0
I can run the USB Audio Sample Application and the USB HID mouse Sample Application which can be found under samples/subsys...
NRF52840 eval kit is configured as ble_app_uart_central and for peripheral, we are using movesense sensor which is running our firmware. The central and peripheral get connected...
Hello everyone,
is there an example that demonstrates how to turn off and on the Bluetooth completely multiple times in the application?
I need really low consumption...
Hi All,
I am new and trying to connect External BLE Pressure Sensor to NRF52840-DK Board
Do you have any example code for interfacing external BLE sensors that I can refer...
Hi, I am trying to connect the AWS_IOT library to a thread netork but find it really hard to get the TLS sockets working. I have connectivity for normal TCP and MQTT as well...
Hello,
our project has a requirement,
nrf52832 is used as a peripheral, and the mobile phone is connected to nrf52832.
The amount of data is relatively large. We want...
