Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
Using nRF51822, I define keys and pins as follows:
Keyboard key
Mouse left/right key
Mouse move (up/down/left/right)
Media play/pause key
Pin 0 Mouse...
The bluetooth device keeps getting disconnected from the app, even when its not 'idle'.
I am using the android app mentioned here .
I need help getting started to solve...
Moving from SDK version 5.1 to 6.0, the buttons on my PCA20006 beacons no longer works as expected. When I press a button, it seems to register the release of a button incorrectly...
I posted another question along these lines, about using the Timeslot API to get observer behaviour with the S110 v7.0 SD, but I am having trouble getting it to work.
Are...
Hello,
We use NRF52 and the SPI protocol to read the ADS7866. But we are facing a problem when reading at high speed, we want to make one read transaction of 2 Bytes every...
Hi everyone,
in our project we transmit from an android app to Nordic BLE big amount of data (up to 180.000 bytes). I do it by using hvx notifications (MTU 247) and each...
I am trying to get nRF52832 working with Segger Embedded Studio. All the examples happily compile and load and run on the board.
But, I want to write my own basic hello...
Hello, I'm using SDK 15.3.0 throughput test and I want to change TX power to +8dBm. In documents it says change the power from sd_ble_gap_tx_power_set but I couldn't find...
Hi everyone,
I'm using the nrf52832 Dev Kit PCA10040
SDK version: 15.3.0
OS: Fedora
I try to use DFU following this tutorial but I can't see my application on...
Using SDK v11.0 and SD v2.0.0 on nRF52832 with ARM GCC.
I want to copy page(s) content to another page(s), I tried the following but couldn't succeed.
When I used the...
Hi,
I am using nRF9160 DK with Zephyr RTOS and able to successfully build asset_tracker in SES with the help of getting started tutorial. But I have getting problem to send...
Hello there,
I have used the nRF52840 DK to find the rssi values of all peripheral devices using the interactive example. I would like to create a command to find the rssi...
Hi,
I am developing sensor products with zigbee (nrf52840).
I have successfully test that sensor data is received by coordinator.
Network is as follows.
ZC(1)...
Hi,
I have a project where my nrf9160 is able to enable and get a fix with GPS and turn in on and off. I am trying to enable LTE when the GPS is off. Here is my procedure...
Hello Nordic,
We have constant success with provisioning servers into the mesh and communicating to smart devices via proxy node. However we do all provisioning with the...
