nRF51 library for Fingerprint Sensor

[Rj_Viki]

Hi !

I have been working on Rhydolabz R305 Biometric sensor using Arduino and I have completed with it . Since this sensor has very low Flash memory to store the Fingerprint template ,I though of using nRF51 and storing those data in cloud and call it.

Where could I get the library file for this fingerprint module either from Adafruit or Rhydolabz for nRF51822

Regards, Raja.

[awneil]

Why not just port your existing Arduino code?

[Roger Clark]

There are also at least 2 Arduino "Cores" for the nRF5x series.

One by RedBearLab and one by Sandeep Mistry.

I suspect if you use Sandeep's core, the library may still compile and run ok without too many changes.

[Rj_Viki]

The problem is the code which I am using right now works perfectly only for Arduino IDE version 1.0.6 when I tried with latest Arduino IDE is was showing some 'Unknown Error'. I asked abt this to Arduino support they adviced me to use the older version as the latest version is not stable. So my question is the nRF Arduino cores supports only for Arduino version 1.6.x. Thats why I asked for any available Library file to code nRF with IAR workbench IDE.

[awneil]

Note that Atmel Studio 7 can take an Arduino "sketch" and turn it into a "normal" C++ project.

Perhaps that would be a way to start porting from Arduino to IAR ... ?

[Manjunath G]

did you get it? if you got then  tell me how to do it, because i am also working on same problem,it would be so helpful to me.