When using FDS, disconnect the Bluetooth connection hint error！

[Jray]

Hi nordic,

nRF5_SDK_14.0.0_3bcc1f7\Raga\examples\ble_peripheral\ble_app_ancs_c FDS\pca10040\s132\arm5_no_packs

I had a problem when I was using FDS，When I use the GC function, when the Bluetooth is disconnected, the system will prompt an error.

If you don't use the GC function, Bluetooth disconnects will not be wrong.

I think the GC operation affected the peer_manager.

Look forward to your reply！

[Jørgen Holmefjord]

Hi,

The error code 12805 (0x3205) corresponds to BLE_ERROR_GAP_DEVICE_IDENTITIES_DUPLICATE, which the documentation describes like this:

The device identity list contains entries with duplicate identity addresses.

You should check your parameters to pm_device_identities_list_set(). I'm not sure how this could relate to FDS garbage collection.

Best regards,

Jørgen

[Jray]

Hi Jorgen,

Thank you very much for your reply! I agree with you, but I don't know how to solve this problem. I'm helpless now.Can you give me your e-mail address? I sent you my test code to see the reason for this error.When I tested, I found that if I use the GC function, the connection will go wrong. Hope to get your help！

[Jørgen Holmefjord]

Please zip the project and upload it by editing your initial question. If you do not want to upload it in public, please create a new case on MyPage, where you link to this post.

[Jray]

Hi Jorgen,

I uploaded the zip attachment, but it didn't work. My mailbox is [email protected], please contact me, I mail to you. Thank you so much for your assistance.

[Jørgen Holmefjord]

What did not work? All support requests should go through our portals. Please try again to upload it, or upload it to some filesharing webpage and post a link here.