nRF8001 Setup

[carabia]

I'm working on integrating nrf8001 with STM32, currently trying to write my own stack. Upon reset, I read the DeviceStartedEvent, 0x81 and it shows "0x02 0x00 0x02", which should mean the device is in the SETUP-state, correct?

After this, I'm trying to send setup (0x06), and the first 30 bytes of the setup array from settings.h created by the nrfgo studio. Upon sending this, the response I get from the device is "0x84 0x06 0x83", which corresponds to invalid device state?

Is there something I'm missing here? Thank you in advance,

Mika

[David Edwin]

You can use the Maple (STM32F series) port to do your integration, or you can use the port that was done for the nRF8001 for the particle.io STM32.

I would suggest that you use the TEST command and then do the ECHO command to test that your SPI interface is good before you start the Setup. Take a look at the testing of the ACI transport section here.

(Apologies for the delay)