Hardware TWI/I2C Example

[danbujak]

The latest TWI example I can find is from 4 SDK revisions ago and uses old libraries. Is there a sample using the nrf_drv_twi library that is recommended for current development?

[MartinBL]

Hi

I have made a simple example using the latest TWI driver in SDK 9. It is very basic;

1. It sets up and configure a TWI instance.
2. Transmits dummy bytes to addresses 0x00 to 0x7F and listens for a response from other TWI devices on the bus.
3. Lights a LED if a device is found.

I have used this example for a while myself just to get me started on a new TWI project. It is simple, but very handy just to see if you have everything connected and set up correctly.

Test examples for SDK 0.9.2, 10.0.0, and 11.0.0: twi-find-devices-on-bus.

twi_simple_SDK9.0.0_v2.zip

EDIT: The folder path to your example .uvprojx file should look like this: "your_SDK9_folder\examples\peripheral\twi_simple_SDK9.0.0_v2\pca10028\arm5_no_packs\twi_simple_SDK9.0.0_v2.uvprojx". The example is meant to be used with the SDK folder structure in the .zip file here. It is not intended for use with the pack installer.

EDIT 2: Updated example: twi_simple_SDK9.0.0_v3.zip

EDIT 3: Response to the questions and comments below regarding build errors:

@NewToNordic is right in his answer below. The latest pack driver and library versions are v3.1.0 with e.g. new TWI drivers that are not compatible with the older examples. This is how I solved it:

• Choose "fixed" from the Selection drop down list.
• Choose version 3.0.1.

• If you get an error complaining about "nrf_drv_config_validation.h": No such file or directory, then just comment out the line in nrf_drv_config.h.
• Then finally enable TWI 1 in nrf_drv_config.h by writing #define TWI1_ENABLED 1.

This worked for me with the 2nd version example in my initial answer and my nRF51 DK kit.

[samet kocatepe]

hi martin thank for fast reply. when i open your example and compile , i faced a build error like image screenshot. can you give any suggest for this.

[MartinBL]

Where did you extract the example? The folder path to your example .uvprojx file should look like this: "your_SDK9_folder\examples\peripheral\twi_simple_SDK9.0.0_v2\pca10028\arm5_no_packs\twi_simple_SDK9.0.0_v2.uvprojx". The example is meant to be used with the SDK folder structure in the .zip file here. It is not intended for use with the pack installer.

[samet kocatepe]

thanks martin. :)

[danbujak]

This driver should be compatible with SDK8.1 as well, correct?