Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
9151 Certification question 0

Subject: nRF9151 – EU coverage of mfw 2.0.2 and antenna gain (Schréder Sense One) Dear Nordic I'm working on CE and RCM certification for Schréder's SENSE ONE smart-city...
14 views

0 replies

Started 37 minutes ago
by fdixon0
Not Answered
nRF54L15 I2C target intermittently stops acknowledging until hard reset 0

We have an nRF54L15 (QFAA) board, acting as an I2C target ( TWIS30, P0.00/P0.01, address 0x42, 100 kHz ) for an ESP32-S3 through a TCA9406 level translator. Flow: Between...
18 views

0 replies

Started 1 hour ago
by MedAvancee
Not Answered
Schematic Review Request: nRF5340 and nPM1100 bluetooth microphone 0

Hello, I am requesting a schematic review of my bluetooth microphone system. I've used the spec sheets as well as audio DK hardware reference material to design these schematics...
19 views

0 replies

Started 1 hour ago
by npwalker
Not Answered
Multiple soldering issues 0

We are seeing very high defect rate when installing this part on boards: insufficient solder, solder bridging. When we look at the pads under the microscope, we are seeing...
26 views

0 replies

Started 5 hours ago
by Loan Thai
Not Answered
nRF9151 puts wrong network in FPLMN 0

Hello, We have an issue. Our device is a custom board based on the nRF9151, and we use it in Latvia. Two network providers are available for our Onomondo SIM card: one supports...
- software
- lte-m
- nb-iot
- nRF9151
- production
32 views

0 replies

Started 10 hours ago
by Matiss

Recent in the DevZone Blog

Serial Wire Debug Port Interface for nRF52832

gamnes

1.1 Description This documentation describes the use and initialization of the Serial Wire Debug Port (SWDP) interface when writing to or reading from Flash and SRAM of the nRF52832 Rev 1. See http:/…
- 2 Jun 2017
nRF52840 GATT Data Throughput with Zephyr RTOS

vich

Nordic has recently contributed support for the 2Mbit/s PHY, part of the Bluetooth 5.0 specification, to the Zephyr Project RTOS. The video below shows how to configure, build and test GATT data throughput…
- 2 Jun 2017
The complete tutorial for developing and debugging nRF52 applications on a Mac

Mohammad Afaneh

I realize that there are already multiple tutorials on how to configure GCC along with Eclipse or SEGGER Embedded Studio (for use on a Mac), but this tutorial goes over setting up a different IDE. The…
- 11 May 2017
Bluetooth 5 2Mbps Demo with nRF52 Series and Samsung Galaxy S8

John Leonard

Bluetooth 5 - now arriving in smartphones As we know, Bluetooth 5 was launched last December by the Bluetooth SIG. The nRF52 Series from Nordic have always had Bluetooth 5 and its arrival in the mix for…
- 9 May 2017
Setting up Segger on a mac or pc and debug - step by step for humans

Lola

Most guides out there are unclear and made for machines. Here is a full guide how to setup Segger for mac OS X with some example project from the SDK ( or even a PC but not tested), and also how to debug…
- 5 May 2017
FreeRTOS threads preview with J-Link, GDB/Eclipse

Radoslaw Koppel

Short note how to make FreeRTOS program debugging with eclipse little simpler. If you are looking the information how to configure the whole environment see this post: https://devzone.nordicsemi.com/tutorials…
- 11 Apr 2017