Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Why is the NRF RRAM Zephyr Flash driver dictating a write_block_size of 16 bytes (one wordline?) 0

While we understand that the RRAMC controller on the nRF54L15 performs writes to RRAM using full wordlines, the datasheet indicates that the nRF54L15 RRAMC supports writes...
- development
- software
- nRF54L15
- zephyr
15 views

0 replies

Started 1 hour ago
by ntennies
Not Answered
9151 Certification question 0

Subject: nRF9151 – EU coverage of mfw 2.0.2 and antenna gain (Schréder Sense One) Dear Nordic I'm working on CE and RCM certification for Schréder's SENSE ONE smart-city...
37 views

0 replies

Started 7 hours ago
by fdixon0
Not Answered
nRF54L15 I2C target intermittently stops acknowledging until hard reset 0

We have an nRF54L15 (QFAA) board, acting as an I2C target ( TWIS30, P0.00/P0.01, address 0x42, 100 kHz ) for an ESP32-S3 through a TCA9406 level translator. Flow: Between...
27 views

0 replies

Started 7 hours ago
by MedAvancee
Not Answered
Schematic Review Request: nRF5340 and nPM1100 bluetooth microphone 0

Hello, I am requesting a schematic review of my bluetooth microphone system. I've used the spec sheets as well as audio DK hardware reference material to design these schematics...
38 views

0 replies

Started 7 hours ago
by npwalker
Not Answered
Multiple soldering issues 0

We are seeing very high defect rate when installing this part on boards: insufficient solder, solder bridging. When we look at the pads under the microscope, we are seeing...
35 views

0 replies

Started 11 hours ago
by Loan Thai

Recent in the DevZone Blog

Bluz, a cloud connected Bluetooth LE development kit based on the nRF51822, is live on Kickstarter

eric ely

Bluz is a brand new development kit that brings Bluetooth LE to the internet. We have paired up with Spark and ported their FW to the nrf51822, allowing Bluz to be controlled and programmed over the…
- 15 Apr 2015
nRF51 current consumption for common scenarios

Stefan Birnir Sverrisson

The following is the estimated nRF51 current consumption during advertising with the DCDC disabled. Advertising 1: TX power: +4dBm adv interval: 20ms (minimum advertising interval in normal adversising…
- 14 Apr 2015
Building kernel for RPi2 with bluetooth_6lowpan for Raspbian

Håkon Alseth

Building kernel for RPi2 with bluetooth_6lowpan In this guide, you will have two choices: Cross-compilation build Native build Choose the one that fits your needs. Cross-compilation is…
- 9 Apr 2015
Debugging with Real Time Terminal

FormerMember

In SDK 12.0.0 or later, logging/debugging over RTT is built in to the logger module NRF_LOG. To enable logging over RTT, "check" the NRF_LOG_BACKEND_SERIAL_USES_RTT option in sdk_config.h in the configuration…
- 8 Apr 2015
Accessing the BLE mesh via the particle.io (spark.io) cloud

David Edwin

Hello. I was spending the last few days to implement an interface to access the BLE mesh via the Internet. The mesh consists of devices with LEDs, which then could be turned on and off in my browser.…
- 1 Apr 2015
How to use the latest Keil 5 for Keil 4 projects (.uvproj)

Stefan Birnir Sverrisson

As many have noticed, Keil 5 does not have native support for Keil 4 projects (project files ending with uvproj), it only has native support for Keil 5 projects (project files ending with uvprojx). However…
- 26 Mar 2015