NCS 3.0.1
nrf52840
nrf21540
I have read several tickets regarding antenna diversity and BLE. It does not seem to be supported for BLE. What about Thread?
I have read...
Affected: nRF Connect SDK v3.4.0; the same code is on main as checked on 2026-11-11 ( subsys/net/lib/nrf_cloud/common/src/nrf_cloud_codec_internal.c , subsys/net/lib/nrf_cloud...
We are currently using an NRF54L15 with TF-M on NCS 3.4.2. We have a custom secure partition, and want it to own a persistent P-256 ECDH private key and derived AES-128 key...
When I connect the two-pin battery and short pin1 and pin2 of P1, I am unable to get the battery voltage at J1 AND WHEN I LEAVE THE PINS UNSHORTED FOR P1, THEN I AM NOT GETTING...
I have connected the correct 47K res for VSET1 but I am not getting 1.8V, instead I am getting 2.3V I am getting the correct output for BUCK2 as 3.3V I have checked the resistor...
With the release of the nRF51 IoT SDK, I guess quite a few would like to start playing with it.
To ease starting up, and enabling you to do a simple "hello world", I have written a step-by-step guide…
Are you looking to make your first steps with Bluetooth Smart?
Are you looking for hands-on help to get started with Bluetooth Smart ?
Playing could be the best form of learning and its time to play…
I recently blogged about Nordic and Hackathons, but didn't include too much information; I knew already there was something coming. And now it is finally published: #HackDublin - Ireland's First Design…
Today, QuickLogic announced the availability of our TAG-N Wearable Sensor Hub evaluation kit for the Nordic Semi nRF51 DK, Nordic’s all-in-one, multiprotocol development kit for ultra-low power wireless…
Recently we introduced support for CMSIS-Pack into our nRF51 SDK. The nRF51 SDK is natively supported in the Keil IDE. This means that nRF51 SDK latest version and example software for nRF51 are easily…
Hi,
I am planning to design a device based on nRF51-dk but with external programmer. I have ST-Link available so I thought I just provide a simple walk through showing how to set it up.
Firstly, here…