Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
DECT MAC: security key by network 0

My DECT nr+ PT supports connecting to either of a set of networks, which of course have different integrity and cipher keys. While scanning for cluster beacons, I can receive...
16 views

0 replies

Started 2 hours ago
by chrysn
Not Answered
Incorrect explicit typecast in lwm2m_connmon.c of nRF Connect SDK 0

Hello, in cases where the LTE signal strength is extremely low, we observed that the LwM2M /4/0/2 RSRP rolls over from -128 to 127. We found that the nRF Connect SDK uses...
15 views

0 replies

Started 2 hours ago
by Christian Zingl
Not Answered
Wireshark BLE sniffer not showing the nRF interface 0

As part of the Bluetooth LE course we need to setup and install the nRF BLE sniffer for wireshark. I have followed the explained steps in the course to set up wireshark to...
17 views

0 replies

Started 3 hours ago
by David012
Not Answered
AT%ENVEVAL In PSM 0

The at command documentation says that ENVEVAL is only available in system mode 2 (CFUN=2). Is there a reason why the command can't be run in any other mode? For example if...
41 views

0 replies

Started 1 day ago
by thomasGronroos
Not Answered
TWIM I2C soft reset function? 0

Hi The TWI driver has a twi_clear_bus() function but the TWIM does not. I'm getting an I2C error, and need to do I2C soft reset. I'm doing this manually at moment but...
58 views

0 replies

Started 4 days ago
by Liam

Recent in the DevZone Blog

Using Two-Factor Authentication (2FA) with the Nordic DevZone

esivertsen

Did you know you can use two-factor authentication to enhance the security of your DevZone account? In this little blog, I’ll show you how to enable Two-Factor Authentication (2FA) with your DevZone account…
- 30 Aug 2018
Introduction of SDH and SDK v15.0 software architecture

Amos Lin

The SDK software architecture has been hugely changed since SDK v13.0. With adding SDH to SDK, it provides SDH API to Enabling the SoftDevice and its event interrupt. Disabling the SoftDevice. Receiving…
- 13 Aug 2018
Bluetooth pairing vulnerability

PaKa

The Bluetooth SIG released an errata for the 4.2 and 5.0 versions of Bluetooth specification on July 23rd relating to a potential vulnerability with the pairing procedures. For Bluetooth low energy; this…
- 27 Jul 2018
Getting Started with the Thingy:52 and GCC/GDB

Daniel Veilleux

The Thingy:52 IoT Sensor Kit is a fancy development board that combines the nRF52832 SoC, a handful of sensors and user interface components, and a rechargeable battery. Although the Thingy is available…
- 20 Jul 2018
Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018