Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Weak TX output power - HW design problem? 0

Hi, I made a custom board with nRF54L15. I do not have a spectrum analyzer, so I cannot tune how much power goes to the antenna or how much is radiated. So, I started ADV...
20 views

0 replies

Started 1 hour ago
by witc
Not Answered
Need to measure the RF power( continuous unmodulated signal) of our custom board 0

We need to measure the RF power(continuous unmodulated signal) of our custom board based on nrf5340 using spectrum analyzer. please suggest the steps and tools to perform...
18 views

0 replies

Started 1 hour ago
by sunaina
Not Answered
Different ADC input voltages result in varying current consumption of the chip 0

Hi Different ADC input voltages result in varying current consumption of the chip,Test as attached, is this normal？
15 views

0 replies

Started 1 hour ago
by sean
Not Answered
Optimizing 10 kHz Data Stream Merging & De-duplication 0

Hi all, I'm working on a Nordic-based system involving multiple nRF52-series chips exchanging high-rate sensor data over both radio and SPI links. The setup involves two...
- development
- code
- software
- nRF52833
- 2.4 ghz
- proprietary
- C
19 views

0 replies

Started 1 hour ago
by Floppey
Not Answered
PPK2 No Device Setup Found 0

Hi, I am facing issues while setting up the PPK2 in one of my desktop. The same hardware is working fine on another desktop. Can you let me know what could be missing...
23 views

0 replies

Started 2 hours ago
by HarishR

Recent in Nordic blog

Introduction of SDH and SDK v15.0 software architecture

Amos Lin

The SDK software architecture has been hugely changed since SDK v13.0. With adding SDH to SDK, it provides SDH API to Enabling the SoftDevice and its event interrupt. Disabling the SoftDevice. Receiving…
- 13 Aug 2018
Bluetooth pairing vulnerability

PaKa

The Bluetooth SIG released an errata for the 4.2 and 5.0 versions of Bluetooth specification on July 23rd relating to a potential vulnerability with the pairing procedures. For Bluetooth low energy; this…
- 27 Jul 2018
Getting Started with the Thingy:52 and GCC/GDB

Daniel Veilleux

The Thingy:52 IoT Sensor Kit is a fancy development board that combines the nRF52832 SoC, a handful of sensors and user interface components, and a rechargeable battery. Although the Thingy is available…
- 20 Jul 2018
Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018