Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Matter ICD example (contact sensor example) not change to LIT mode with Apple home kit 0

I build contact sensor example (use nrf connect sdk v3.2.1, nrf52840 chip) and try commissioning with apple home kit (use homepod mini), device commissioning succeed but cannot...
15 views

0 replies

Started 2 hours ago
by sangphan
Not Answered
Using NCS Docker image with JLink 0

Hi devzone, I am starting to write some tests for my application, and I have a couple questions/remarks about the provided Docker image. Link to documentation . 1/ The...
14 views

0 replies

Started 13 hours ago
by NicolasGoualard
Not Answered
I am trying to install the SDK and whilst I can get to the point of installing v3.2.0 or v3.2.1 the installation fails with Failed to read toolchain environment 0

I have done a clean install of the SDK on Debian 13 I have nrfutil install and its working fine - i have tried installing both the v3.2.1 and v3.2.0 toolchains and in both...
28 views

0 replies

Started 17 hours ago
by simonp119
Not Answered
PAwR response delayed by one periodic interval 0

Hello, We are using 2 nRF5340-based devices running: samples/bluetooth/periodic_adv_rsp samples/bluetooth/periodic_sync_rsp with the PAwR configuration (modified...
24 views

0 replies

Started 1 day ago
by droid
Not Answered
Benchmark for BLE receiver performance 0

Hello, we are testing the BLE ADV capabilities and also MESH performances on NRF54L15. We verified that, in conditions of continuous scanning (interval = 30ms), the packet...
35 views

0 replies

Started 1 day ago
by barbiz

Recent in the DevZone Blog

Bluetooth pairing vulnerability

PaKa

The Bluetooth SIG released an errata for the 4.2 and 5.0 versions of Bluetooth specification on July 23rd relating to a potential vulnerability with the pairing procedures. For Bluetooth low energy; this…
- 27 Jul 2018
Getting Started with the Thingy:52 and GCC/GDB

Daniel Veilleux

The Thingy:52 IoT Sensor Kit is a fancy development board that combines the nRF52832 SoC, a handful of sensors and user interface components, and a rechargeable battery. Although the Thingy is available…
- 20 Jul 2018
Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018