Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Weak TX output power - HW design problem? 0

Hi, I made a custom board with nRF54L15. I do not have a spectrum analyzer, so I cannot tune how much power goes to the antenna or how much is radiated. So, I started ADV...
20 views

0 replies

Started 1 hour ago
by witc
Not Answered
Need to measure the RF power( continuous unmodulated signal) of our custom board 0

We need to measure the RF power(continuous unmodulated signal) of our custom board based on nrf5340 using spectrum analyzer. please suggest the steps and tools to perform...
18 views

0 replies

Started 1 hour ago
by sunaina
Not Answered
Different ADC input voltages result in varying current consumption of the chip 0

Hi Different ADC input voltages result in varying current consumption of the chip,Test as attached, is this normal？
15 views

0 replies

Started 1 hour ago
by sean
Not Answered
Optimizing 10 kHz Data Stream Merging & De-duplication 0

Hi all, I'm working on a Nordic-based system involving multiple nRF52-series chips exchanging high-rate sensor data over both radio and SPI links. The setup involves two...
- development
- code
- software
- nRF52833
- 2.4 ghz
- proprietary
- C
19 views

0 replies

Started 1 hour ago
by Floppey
Not Answered
PPK2 No Device Setup Found 0

Hi, I am facing issues while setting up the PPK2 in one of my desktop. The same hardware is working fine on another desktop. Can you let me know what could be missing...
23 views

0 replies

Started 2 hours ago
by HarishR

Recent in Nordic blog

Start Up Extreme Norway

John Leonard

Last week I attended what was my first Startup event, but after experiencing the energy there, I can safely say it will not be my last. 3 days of seminars, networking and lots of fun kicked off in Bergen…
- 22 Jun 2015
Step by Step Guide to Setup and Start Developing with the nRF51 DK and Keil

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, get the tools installed and get the software (SW) development environment…
- 17 Jun 2015
Debugging using QtCreator on Mac

wim

This post started as a question, but got the suggestion to post this as a blog post. Here it is. I have been trying to get QtCreator configured such that I can use it as my IDE for the nrf51822 on Mac…
- 12 Jun 2015
Trying OpenWRT Chaos Calmer (15.05 RC1) on Raspberry Pi 2

Jun Qing ZOU

| |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D…
- 11 Jun 2015
Trying OpenWRT Chaos Calmer (15.05 RC1) on Asus RT-N16

Jun Qing ZOU

| |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D…
- 11 Jun 2015
Compatibility between DFU bootloader and DFU master

Hung Bui

We have been receiving quite a few questions about the compatibility issue between the bootloaders from different SDK versions and the DFU master such as nRF Master Control Panel, nRFToolbox, etc. In…
- 10 Jun 2015