Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
SoftDevice BLE chained advertisement not reassembled by Bluez Stack 0

Hi, I am trying to configure an Xiao Seeed Studio nrf54l15 sense to transmit pre-processed sensor data via BLE extended advertisements. As the payload is more than 251 bytes...
6 views

0 replies

Started 37 minutes ago
by rory0
Not Answered
nRF9151 Max Data Rate with v2.0.0 PHY firmware 0

In this post mentioned: "Maximum theoretical peak data rate is 3.4 Mbps when transmission is scheduled into packets of 4 slots using MCS4, and these 4 slot packets are transmitted...
2 views

0 replies

Started 1 hour ago
by Zach Williams
Not Answered
# nRF54L15 NS+TFM: `soc_flash_nrf_rram` driver missing secure-flash read for DTS-only partitioning → SECURE FAULT on `mcumgr image list` 0

Summary The Zephyr RRAM driver drivers/flash/soc_flash_nrf_rram.c does not pass NS-side reads of TF-M secure flash through soc_secure_mem_read when the device tree uses...
6 views

0 replies

Started 1 hour ago
by Dominic
Not Answered
nRF5340 (NCS v2.8.0) - External rail-to-rail LFXO source: boot hangs, external oscillator stops toggling 0

I want to use a new source LF clock to raise the precision from +-250ppm to around +-20ppm. I already have an oscillator mounted in my PCB, so I want to use it for BLE. I...
20 views

0 replies

Started 6 hours ago
by Alvaro Arnaiz
Not Answered
Azure FOTA w/o Partition Manager (NCS v2.9.3) 0

Hi, I would like to know if its possible to run Azure FOTA functionality w/o using Partition Manager (aka `SB_CONFIG_PARTITION_MANAGER=n`) ? Trying to build this gets...
37 views

0 replies

Started 8 hours ago
by Andrei H.

Recent in the DevZone Blog

nRF52832-QFN Eagle Part/Footprint

ble_Man

Hello everyone, I've started an nRF52832 library for those devs who are interested in creating their PCB's in Eagle. Its the QFN chip right now. I read somewhere that a BGA version is planned also, so…
- 24 Jun 2015
Start Up Extreme Norway

John Leonard

Last week I attended what was my first Startup event, but after experiencing the energy there, I can safely say it will not be my last. 3 days of seminars, networking and lots of fun kicked off in Bergen…
- 22 Jun 2015
Step by Step Guide to Setup and Start Developing with the nRF51 DK and Keil

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, get the tools installed and get the software (SW) development environment…
- 17 Jun 2015
Debugging using QtCreator on Mac

wim

This post started as a question, but got the suggestion to post this as a blog post. Here it is. I have been trying to get QtCreator configured such that I can use it as my IDE for the nrf51822 on Mac…
- 12 Jun 2015
Trying OpenWRT Chaos Calmer (15.05 RC1) on Raspberry Pi 2

Jun Qing ZOU

| |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D…
- 11 Jun 2015
Trying OpenWRT Chaos Calmer (15.05 RC1) on Asus RT-N16

Jun Qing ZOU

| |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D…
- 11 Jun 2015