Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
case about nRF54L10 VREF0.9V 0

Hi, The VREF0.9V used by the internal ADC of 54L10 has a tolerance of how much and what is its accuracy range? Best regards. Peter.Min
5 views

0 replies

Started 15 minutes ago
by peter.min
Not Answered
Not being able to install Serial LTE Modem through Quickstart app. Verification error. 0

Hello, I am trying to configure the NRF9151-DK, but when opening Quickstart app it cannot verify the board. Here's the log. I've been working with exact same boards, also...
19 views

0 replies

Started 6 hours ago
by cedavitkovac
Not Answered
Can nRF54L sEMMC be used with an SD card or SD NAND? 0

Hi, We are considering using the new sEMMC SoftPeripheral on the nRF54LM20A with a 4-bit SD card or soldered SD NAND instead of eMMC. Has anyone tried this? Does it work...
49 views

0 replies

Started 10 hours ago
by Treee
Not Answered
nRF91, RAI with PPP 0

Hello We are developing a new product using the nRF54LM20 as a main MCU and nRF9151 as the modem. We are looking into using the IP-stack in the main MCU, so running the...
35 views

0 replies

Started 15 hours ago
by MattiasE
Not Answered
nRF54 Debug Interface During Abrupt Power‑Off 0

HI My gateway adopts CAT1 and nRF54, which communicate with each other via UART. The UART signals from the CAT1 module are 3.3 V level translated by the TXB0108 and fed...
52 views

0 replies

Started 17 hours ago
by joey

Recent in the DevZone Blog

What impact does the deprecation and withdrawal of Bluetooth Core specification v4.0 and v4.1 have on your current and future products?

Petter Myhre

This blog was last updated 17.01.2019. The Bluetooth Special Interest Group (SIG) recently announced the deprecation and withdrawal of Bluetooth Core specifications v4.0 and v4.1. For products that are…
- 30 Oct 2018
The S132 v5.1.0 is now production tested on nRF52810

Petter Myhre

This blog describes how you can setup a Segger Embedded Studio example for PCA10040E (emulating nRF52810) from nRF5 SDK 14.2 to use S132 v5.1.0, instead of S112. The procedure should be similar for the…
- 12 Sep 2018
Adding custom commands to a BLE example using Nordic UART Service

Håvard

A common thing to do is to use the Nordic UART Service for quick prototyping. Often the example itself is used as a starting point (ble_app_uart). But sometimes we use other starting points, and want to…
- 6 Sep 2018
Using Two-Factor Authentication (2FA) with the Nordic DevZone

esivertsen

Did you know you can use two-factor authentication to enhance the security of your DevZone account? In this little blog, I’ll show you how to enable Two-Factor Authentication (2FA) with your DevZone account…
- 30 Aug 2018
Introduction of SDH and SDK v15.0 software architecture

Amos Lin

The SDK software architecture has been hugely changed since SDK v13.0. With adding SDH to SDK, it provides SDH API to Enabling the SoftDevice and its event interrupt. Disabling the SoftDevice. Receiving…
- 13 Aug 2018
Bluetooth pairing vulnerability

PaKa

The Bluetooth SIG released an errata for the 4.2 and 5.0 versions of Bluetooth specification on July 23rd relating to a potential vulnerability with the pairing procedures. For Bluetooth low energy; this…
- 27 Jul 2018