Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
A solution for synchronizing WS2812 and DMX512 light animations using the nRF54L15 0

Hello friends from all over, I am a beginner. Recently, I have been working on synchronizing lighting animation effects between devices driven by a mesh network and have encountered...
16 views

0 replies

Started 57 minutes ago
by GG Bond
Not Answered
SB_CONFIG_MCUBOOT_HARDWARE_DOWNGRADE_PREVENTION + SB_CONFIG_MERGED_HEX_FILES fails to configure without NSIB 0

Setup: nRF Connect SDK v3.4.0 (LTS), custom board based on nRF54LM20A, sysbuild with MCUboot as the only bootloader (no NSIB / b0), DTS partitions (SB_CONFIG_PARTITION_MANAGER...
25 views

0 replies

Started 9 hours ago
by Konstantin Klitenik
Not Answered
Two-chip design (nRF54L + nRF9151): best configuration, handle FOTA of both firmwares over NB-IoT and over BLE 0

Hi, We are designing a battery-powered product based on two Nordic chips and would like your recommendation on the overall architecture before we freeze the hardware, having...
- development
- nb-iot
- nRF9151
- bluetooth le
- hardware
- nRF54L10
35 views

0 replies

Started 11 hours ago
by ruben94m
Not Answered
nRF93M1 mfw 1.5.0: TERMINAL CAPABILITY IPAd bit for SGP.32 eUICCs 0

Hi, GSMA SGP.32 v1.3 section 3.8.2 and 3.8.4: the device selects IPAd or IPAe mode with the TERMINAL CAPABILITY command at UICC initialisation. Tag 84 , byte 1, bit 1 set...
32 views

0 replies

Started 12 hours ago
by erkkie
Not Answered
I2S, or SPI Compatibility with PCM Short, and Long Synch frames 0

Hello I'm developing a project that would communicate with a cellular module using AT-Commands, and voice data using PCM, these cellular modules are always using PCM Short...
36 views

0 replies

Started 14 hours ago
by Beshoy

Recent in the DevZone Blog

Introduction of SDH and SDK v15.0 software architecture

Amos Lin

The SDK software architecture has been hugely changed since SDK v13.0. With adding SDH to SDK, it provides SDH API to Enabling the SoftDevice and its event interrupt. Disabling the SoftDevice. Receiving…
- 13 Aug 2018
Bluetooth pairing vulnerability

PaKa

The Bluetooth SIG released an errata for the 4.2 and 5.0 versions of Bluetooth specification on July 23rd relating to a potential vulnerability with the pairing procedures. For Bluetooth low energy; this…
- 27 Jul 2018
Getting Started with the Thingy:52 and GCC/GDB

Daniel Veilleux

The Thingy:52 IoT Sensor Kit is a fancy development board that combines the nRF52832 SoC, a handful of sensors and user interface components, and a rechargeable battery. Although the Thingy is available…
- 20 Jul 2018
Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018