hi
after success dfu operation the firmware start to run
then i am getting stuck write after err_code = sd_ble_gap_device_name_set(&sec_mode, new_name, DYNAMIC_NAME_LEN...
I've been following the information on the nRF54H20 with interest as it is most likely the natural candidate for upgrading our existing design. However, I have been waiting...
We are developing an application on nrf52840 and wanted to use M95P32 as external flash.
used below .overlay configuration to enable it on zephyr.
&mx25r64 {
compatible...
Hi,
Using nRF Connect SDK 2.7.0 on an nRF9160. Using native tls, works fine, i can setup HTTPS connections.
Problems arise when i try to use MQTT with native TLS (with...
Hello Nordic DevZone community,
I have been working with the ZBOSS stack on the nRF5340 and understand that it has version management and migration features for persistent...
Bluetooth LE is not a fast wireless protocol, transfer speeds are usually measured in single-digit to low tens of kilobytes per second. This is generally not an issue unless large amounts of data need…
PCB Design
Abstract:
The SkyenLab Bluetooth module was developed using the nrf51422 QFN48 QFAC reference design as well as help from the Nordic Semiconductor support portal and white papers. A proof…
Our Project
This post is to clarify team SkyenLab’s scope for satisfying the senior design class requirements and Nordic Semiconductor requirements during the first semester (Aug. 2015 - Dec. 2015) of…
TL;DR: It ignores whatever the computer tells it to do and does an automatic detection.
And the reason? UART terminals are not doing flow control settings in a consistent way, and in some cases incorrectly…
Introduction
A few months ago I started running again. Music helps me to stay motivated. Since most earphones keep falling out, especially when the sweat comes out, I googled for some sports earphones…
List of changes from µESB to nrf_esb
All functions, structs, enums and defines have been renamed from uesb_xxx to nrf_esb_xxx.
Events:
Events used to be triggered within radio interrupt context…