Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
nRF5340 BLE Audio Request for Schematic Review 0

I am designing an ultra-low-power BLE Audio TWS board based on the nRF5340 and have followed the recommended hardware design guidelines throughout the project. This is my...
- Evaluation
- nPM1100
- bluetooth le
- low-power
- rf design
- hardware
- nRF5340
41 views

0 replies

Started 1 hour ago
by DavidMorina103
Not Answered
b0 fails to boot using swap algorithm in SDK 3.2.1 in nrf5340 0

Hello! We are in the middle of an upgrade to 3.2.1, and we encounter the following issue using SB_CONFIG_MCUBOOT_MODE_SWAP_WITHOUT_SCRATCH, SB_CONFIG_MCUBOOT_MODE_SWAP_USING_MOVE...
29 views

0 replies

Started 2 hours ago
by AlejandroM
Not Answered
BLE disconnect reasone 8 0

Hi everyone, I'm using the nRF5340 on a custom PCB board without an external 32 kHz oscillator. On the network core I flashed the hci_ipc sample. For some reason I occasionally...
38 views

0 replies

Started 3 hours ago
by Petar02
Not Answered
DECT NR+ rssi-1 measurement results saturated 0

Hello, I am measuring RSSI values with nrf_modem_dect_phy_rssi(...) from the DECT PHY firmware. The nrf_modem_dect_phy_rssi_event refers to positive values being saturated...
25 views

0 replies

Started 4 hours ago
by dame
Not Answered
DPPI and GPIOTE BLE events on nRF54L15 0

Hi all, I'm working on BLE time synchronization between nodes using hardware timestamps via GRTC + DPPI + PPIB cross-domain. CRCOK and PHYEND work perfectly, but adding...
46 views

0 replies

Started 5 hours ago
by ArneVds

Recent in the DevZone Blog

Weird issue with pyserial flow control

Eirik Midttun

EDIT: It seems less weird now. See You will never guess how JLink deals with UART flow control for the full story. Working on some Python code to control nRF51 and nrF52 targets I encountered a strange…
- 29 Jan 2016
Comparing compilers/IDEs for development with nRF5x series devices

Michael Dietz

#Introduction All compilers ARE NOT created equal. Given the same c code, different compilers will generate machine code with varying performance & size. Generally the more efficient machine code (uses…
- 28 Jan 2016
nRF52 Range Extension with RFaxis' RFX2411N

Floyd Ashbaugh

External Power Amplifiers and LNAs easily connected to the nRF52 series device for high power extended range operation. Data sheets, white papers, schematics and layout information available at link t…
- 26 Jan 2016
Developing Nordic nRF51 applications with mbed and Visual Studio

ivan

This tutorial shows how to use the mbed framework to develop applications for Nordic nRF51 devices. Before you begin, install VisualGDB 5.1 or later. Start Visual Studio and open the VisualGDB Embedded…
- 26 Jan 2016
PA / LNA support in S132

Einar Thorsrud

The S132 SoftDevice for the nRF52 has support for enable/disable switching of external Power Amplifiers (PA) and Low Noise Amplifiers (LNA) using GPIO pins. This was introduced in S132 version 2.0.0-7…
- 25 Jan 2016
Step by Step Guide to Setup and Start Developemt with nRF51 or nRF52 DK and IAR

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, to get the necessary tools installed and get the software (SW) development…
- 25 Jan 2016