Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
VPR hibernate 0

i'm writing bare-metal code for the FLPR (which was loaded by a bare-metal launcher running on the M33).... when my FLPR code "idles" using the WFI instruction, power consumptions...
23 views

0 replies

Started 2 hours ago
by bios-bob
Not Answered
Using the Softdevice Controller without RTC Crystal 0

I want to use the Softdevice Controller without a crystal on the RTC. I configured my project with Advertiements look fine, but interaction with a BLE central either throw...
61 views

0 replies

Started 1 day ago
by Sven Haedrich
Not Answered
NRF5340-AUDIO Unicast-Server / Unicast-Client configuration 0

Hi everyone, These days I'm evaluating the Nordic nRF5340 to manage audio from two microphones to one dongle station. To achieve this, I configured two nRF5340s as unicast...
58 views

0 replies

Started 1 day ago
by Pier Luigi
Not Answered
Planning to use 3.7V non-Rechargable battery with npm2100 with an additional diode? 0

I am planning to use 3.7V non Rechargable Battery with Diode and Reverse Protection circuit with npm2100, Would like to build a Fuel Guage model for this as this is not available...
59 views

0 replies

Started 1 day ago
by rsramki
Not Answered
MCELL search type for lte_lc_neighbor_cell_measurement() 0

Hello, I am currently evaluating MCELL location on an existing project, based on nRF9160. After some trial and errors, I managed to get it working. However, I ma a bit...
41 views

0 replies

Started 1 day ago
by Vincent44

Recent in the DevZone Blog

Developing Nordic nRF51 applications with mbed and Visual Studio

ivan

This tutorial shows how to use the mbed framework to develop applications for Nordic nRF51 devices. Before you begin, install VisualGDB 5.1 or later. Start Visual Studio and open the VisualGDB Embedded…
- 26 Jan 2016
PA / LNA support in S132

Einar Thorsrud

The S132 SoftDevice for the nRF52 has support for enable/disable switching of external Power Amplifiers (PA) and Low Noise Amplifiers (LNA) using GPIO pins. This was introduced in S132 version 2.0.0-7…
- 25 Jan 2016
Step by Step Guide to Setup and Start Developemt with nRF51 or nRF52 DK and IAR

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, to get the necessary tools installed and get the software (SW) development…
- 25 Jan 2016
BLE nrf51 - Multilink NUS central - Connect to many peripherals through NUS service - with Arduino host

Marco Russi

Hi all, I implemented a simple multilink NUS central based on s130 for nrf51 chip-set. It means that this NUS central can connect to several peripherals simultaneously and send data to each one of them…
- 24 Jan 2016
SEGGER Embedded Studio Part 2 - Monitor Mode Debugging

Michael Dietz

This tutorial will take less than 15 minutes. #Motivation Never lose a BLE connection when debugging your applications again! This technique will also be useful for any application using the PWM peripheral…
- 22 Jan 2016
An introduction to error handling in nRF5 projects

Audun

As you start developing with the nRF5 series chips, SoftDevices, and SDKs, it's very useful to learn how errors can be discovered (and preferrably recovered from). This can be detecting something as simple…
- 20 Jan 2016