Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
About Tx current consumption in nRF54L 0

Hi, I am currently developing an nRF54L15 module. During the evaluation, I measured the Tx current consumption and got a result that was 2mA higher than the value listed...
33 views

0 replies

Started 6 hours ago
by H-ogawa
Not Answered
EOL Parts on the nRF7002 DK 0

Hello, I am working on custom hardware that is based on the nRF7002 DK. The following parts are presently listed as either EOL or NRND in distribution. L6, L8: Taiyo Yuden...
20 views

0 replies

Started 7 hours ago
by SeattleChris
Not Answered
Channel sounding performance benchmark 0

Hello, we are testing the channel sounding performances for distance measurement with the example: https://docs.nordicsemi.com/bundle/ncs-2.9.1/page/nrf/samples/bluetooth...
27 views

0 replies

Started 9 hours ago
by barbiz
Not Answered
How to connect/configure I2C devices on the nrf9151dk 0

I am trying to connect some I2C sensors to the the nrf9151dk and I cannot figure it out. Where do I physically plug the sensor into the board and what configuration setting...
21 views

0 replies

Started 10 hours ago
by mdede439
Not Answered
Migrating Issues from 1.7.0 to 2.7.0 SDK 0

Hello, I am having issue to migrate a working project based on Azure IoT Hub Application code from 1.7.0 to 2.7.0, I have resolved all errors associated with changing the...
- development
- software
- nRF9160
- zephyr
18 views

0 replies

Started 10 hours ago
by Kirolos Sedra

Recent in Nordic blog

FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015
ADXL 345 Tutorial

Milad

Hello all, this tutorial goes to a fellow named Emil who helped me with this project. Number 1_ Make sure you set up the terminal viewer For debugging with real.You need it to see the values coming outta…
- 1 Aug 2015